Gamma 5003 Руководство пользователя - Страница 11
Просмотреть онлайн или скачать pdf Руководство пользователя для Машины для изготовления струн Gamma 5003. Gamma 5003 20 страниц. 6 point mounting
Также для Gamma 5003: Руководство пользователя (20 страниц), Руководство пользователя (19 страниц), Руководство пользователя (20 страниц)
Печатать страницу
position to the clamped position and back, generally requires the rotation permitted by the slot
in the clamp base. If the rotation is not sufficient to allow smooth operation, adjust the Clamp
Base Locking Nut as outlined on pg 11.
Note: If the string slips in the string clamp while tensioning, adjust the gap between the clamp
jaws as per the following instructions.
STRINGING THE FRAME
Clamp Base Operation
Rotate the Base Locking Lever clockwise to
secure the clamp base to the turntable.
Reverse the clamping procedure to unlock
the string clamp. The Locking Lever is spring
loaded to assist the unlocking of the clamp
base.
The Locking Lever should be tightened
enough to prevent clamp base slippage on
the turntable, when the desired tension is
placed on the string. To go from the loose
Clamping the First Main String
To begin stringing the main strings, thread
the two ends of the string through the two
center holes at the appropriate end of the
frame and continue through the opposite
center holes. Thread one end of the string
through the adjacent grommet hole and pull
excess by hand.
Secure one of the strings using a string
clamp.
Pulling Tension
Wrap
the loose section of string once
around the roller guide and insert the string
between the diamoind dust coated string
gripper plates. Pull the string perpendicular
to the gripper plates while slowly rotating the
tensioner crank clockwise until the brake
lever pops out of the latching block. The
string is now tensioned and can be clamped
in place with the remaining fixed clamp.
Repeat the above steps until all main strings
are installed. Tie off ends of main strings as
per racquet manufacturers recommenda-
tions.
10