Gamma 7000 Es Руководство пользователя - Страница 8

Просмотреть онлайн или скачать pdf Руководство пользователя для Машины для изготовления струн Gamma 7000 Es. Gamma 7000 Es 20 страниц.

tional separation space between the mounting arms. The outer holes should be used whenever

possible provide maximum support for securing the support post to the turntable.

alcohol. After this type of thorough cleaning, the post and tube should be treated with a light

coating of machine oil to protect the surfaces against corrosion and to ensure smooth operation.

ASSEMBLY INSTRUCTIONS

Installing the Racquet Mounting System

Align the threaded hole in the bottom of the

frame support post with the slot in the turn-

table. Screw the lever lock bolt with washer

into the outermost hole located in the bottom

of the support post and tighten gently.Position

the washer with the rounded edge toward the

turntable.

Repeat procedure for the support post on the

opposite side of the turntable.

There are two holes located in the bottom of

the support post. The inner hole is for use

with super oversize racquets to provide addi-

Installing the Fixed Clamps

To install the clamps, remove the winged

lock knob to separate the knob from the lower

guide bushing. Be careful not to lose the

radial thrust bearing components located in

the center recess of the knob.

Align the clamp base with the clamp slot of

the turntable base. Insert the clamp guide

bushing into the clamp from the bottom of the

turntable making sure to engage the guide

with the clamp slot.

Fixed Clamp Installation

Place the load bushing into the top of the

clamp base mating it to the lower guide

bushing. After checking that the thrust bear-

ing is positioned correctly in the base of the

winged lock knob, screw the knob into the

base bushing until fully seated.

The post of the string clamp head and tube of

the string clamp base are treated with grease

to provide protection against corrosion dur-

ing shipping. Remove any excessive grease

with a clean cloth prior to use. The post and

tube may also be cleaned with isopropyl