Airflow ACES48SS Инструкции по установке - Страница 3
Просмотреть онлайн или скачать pdf Инструкции по установке для Вентилятор Airflow ACES48SS. Airflow ACES48SS 4 страницы. Ceiling sweep fan
Печатать страницу
ACES48ALR
6.0 Connecting the Fan
All Airfl ow Ceiling Sweep Fans are pre-wired to allow for a light
to be fi tted onto the fan.
If you are not fi tting a light to the fan, please disregard the light
wires. The wires are connected to the incoming wiring as
illustrated in the below diagram.
NEUTRAL
SUPPLY
230-240V~ 50Hz
ACTIVE
RED
BROWN
REMOTE CONTROL
RECEIVER
BLUE
RED BROWN BLUE
TO REMOTE
TB2
TO FAN
RED BROWN BLUE
BLUE
BROWN
RED
7.0 Mounting the Remote Control
Mount the cradle in a convenient location. The handset can be
stored in the cradle.
Cradle
8.0 Operating Your Fan
• Forward/reversible switch on motor housing controls air
movement
Caution: Before changing forward/reversible switch, turn
the fan OFF and ensure that the fan has stopped rotating
to prevent injury to yourself and damage to the motor.
REMOTE CONTROL:
• Use the infrared remote control to change the speed of the fan
as well as to switch both the fan and light on and off. (If a light
fi tting is attached to the fan)
• Replace the batteries by sliding the battery compartment
panel on the remote in the direction of the arrow. Fit two
'AAA' batteries, ensuring polarity as shown in the battery
compartment. (Note: batteries NOT included). Slide on
the battery compartment cover
• ALWAYS ensure that the battery compartment panel is secure
• NEVER leave the remote control in direct sunlight
• NEVER attempt to recharge primary batteries, either in a
charger or by applying heat to them. There are special
rechargeable batteries which are clearly marked as such
• NEVER dispose of batteries in fi re, because this can cause
them to explode
• The light can be controlled on and off by pressing the light
'ON/OFF' button on the remote control transmitter
• The level of light brightness can be adjusted by pressing and
holding the 'DIMMER' button on the remote control transmitter
© Clipsal Australia Pty Ltd
EARTH
BROWN
BLUE
L
N
TB1
BROWN
BLUE
BROWN
BLUE
GREEN/YELLOW
Handset
• The speed can be selected by pressing the 'SPEED' button on
the remote control transmitter:
HI - High Speed
MED - Medium Speed
LOW - Low Speed
OFF - Off.
9.0 Operating Instructions
Light ON/OFF
Light Dimming
NOTE
Light dimming only works when a light fi tting is attached to the
fan and the lamps are compatible with dimmers. Most fl uorescent
lamps are not compatible with dimmers.
Summer/Winter Settings
The forward/reversible switch is located on the bottom cowl.
Check switch and make sure it is in correct setting, depending on
cold weather or hot weather.
Cold weather: Push switch down for the blades to circulate the
warm air trapped near the ceiling.
Hot weather: Push switch up for the blades to create a breeze
and circulate the air.
NOTE
The forward/reversible switch must be fully engaged for the fan
to operate.
Cleaning Instructions
To clean the fan, wipe over with a damp, soapy cloth.
Do not use scourers or abrasive cleaners.
ALL ELECTRICAL WORK MUST BE CARRIED
OUT BY A QUALIFIED ELECTRICIAN.
Ceiling Sweep Fan Installation Instructions
Fan Speed
AIRFLOW
REMOTE
Fan OFF
CONTROL
SUMMER
WINTER
3 of 4