IKEA SKYTTA Руководство по установке - Страница 9
Просмотреть онлайн или скачать pdf Руководство по установке для Внутренняя отделка IKEA SKYTTA. IKEA SKYTTA 16 страниц.
Также для IKEA SKYTTA: Руководство по установке (16 страниц)
- 1. Table of Contents
- 2. Sliding Doors for All Spaces with SKYTTA
- 3. Tools
- 4. Before You Start
- 5. SKYTTA Parts
- 6. To Think about
- 7. Height Options
- 8. The Doors Fit Perfectly
- 9. A Little Space Left above the System
- 10. A Lot of Space Left above the Door
- 11. The Doors Are too High
- 12. Sloped Ceiling
- 13. More Information
- 14. Services
Door assembly
Door has two symmetrical side rails, bottom rail and top rail, marked with tape.
Wheel fitting is placed in the bottom and guide fitting in the top. Click in the hori-
zontal bars on the side rails and spared them out so they match the height just
above the fillers. Guide pins with wings shall be placed to match activator between
doors.
DRAFT
DRAFT
DRAFT
Door fillers
Door fillers are centred between the door side rails. Make sure that the panel is
inside the gasket flange. Never leave the filler without mounting the horizontal bar
or the top lid closed for the top filler. Plastic pin in the bar clicks in is to secure that
it can't be released.
Adjust door/activate soft close
By adjusting the wheel fitting's height, you can adjust the gap between the doors
and the door/wall. Release the two screws and turn the adjustment between the
screws. You have +/-2 mm on each wheel.
Soft closing is activated by moving the door all the way to the wall. You will hear a
click and after that the soft closing should work.
Top cover
Top cover is symmetric and clicked on the ceiling rail on both sides. If you are con-
necting two top rails, make sure the cut end is towards the wall.
Mount door/clean floor rail
Clean the floor rail before mounting as dust can get stuck on the wheels. This
should be done regularly to maintain a nice sliding of the doors. Follow the layout
with activator/soft closing. Guide pins with wings shall be connected to activator/
soft closing between doors.
1
2x
2
Door handle
Door handle click into the door side rail. To get it into the correct position, the cut
out on the handle should match the plastic clip mounted on the backside of the
middle bar. This prevents the handle from moving vertically and makes all handles
match in height.
Home position middle doors
When a door has its closed position in the middle and not to a wall, you mount the
home position. Home position is working together with the door guide and activa-
tor. Home position has a wing nut that grips into the aluminium track during assem-
bly. Adjust by releasing the screw, slide to new position and tight the screw.
2x
9