Brita C150 FINEST Инструкции по установке

Просмотреть онлайн или скачать pdf Инструкции по установке для Системы фильтрации воды Brita C150 FINEST. Brita C150 FINEST 5 страниц.

BRITA C150 FINEST

INSTALLATION INSTRUCTIONS

Please read carefully and retain for future reference.

CONTENTS

Important Information

Included Parts

Filter Head Assembly Instructions

Installation Instructions

4.1. Auxiliary Tap Connection

Plumbing in Your System

Replacing the Filter Cartridge

Warranty Information

1. Important Informa�on

For correct operation of this appliance, it is essential to strictly observe these installation and operating instructions.

Do not use this product with water that is microbiologically unsafe or water of unknown quality without adequate disinfection before or

af t er this system.

Installation must comply with any existing State or Local Plumbing codes. Some Plumbing Codes require the installation of water filter

systems to be carried out by a licensed plumber.

For COLD water use only. Maximum temperature 38°C. Minimum temperature 2°C.

For internal use only.

The inlet water pressure to this water filter housing must not exceed 900kPa (130psi).

A certified pressure limiting valve not exceeding 650kPa (95psi), dual check backflow prevention valve must be installed on the inlet line

immediately preceding this water filter housing. This valve is included with this system (see Item 10 in Parts Section).

We also recommend the installation of a water hammer protection device to protect the water filter housing and its installation. Where

water hammer problems exist, a water hammer protection device must be installed. Symptoms of water hammer can be noisy, shuttering

and banging pipes when water consuming appliances are operating or taps are turned off. Should the system not be used for 2 days or more,

flush 1-2 litres of water through the system before consuming the water.

To ensure the high level of performance and protection provided from this water filter system, only use Bombora replacement cartridges

which have a maximum cartridge life of 12 months.

Af t er installation, check the output water with a test strip and then test every 6-8 weeks af t erwards to establish your filter life based on your

average use. The TH reading should be below low range (less than 80PPM). If you get a higher reading than this on installation, call us to

discuss adjusting your bypass setting or restricting water flow further. Suggested filter cartridge change is 12 months or when the sof t ening

capacity is diminished (over 80 PPM TH), whichever comes sooner.

bomborasupplies.com.au

1300 724 249

PART # C150KIT-FINEST