Brita C150KIT-FINEST Инструкции по установке

Просмотреть онлайн или скачать pdf Инструкции по установке для Системы фильтрации воды Brita C150KIT-FINEST. Brita C150KIT-FINEST 5 страниц.

BRITA C150 FINEST

INSTALLATION INSTRUCTIONS

Please read carefully and retain for future reference.

CONTENTS

Important Informa�on

Included Parts

Filter Head Assembly Instruc�ons

Installa�on Instruc�ons

4.1. Auxiliary Tap Connec�on

Plumbing in Your System

Replacing the Filter Cartridge

Warranty Informa�on

1. Important Informa�on

For correct opera�on of this appliance, it is essen�al to strictly observe these installa�on and opera�ng instruc�ons.

Do not use this product with water that is microbiologically unsafe or water of unknown quality without adequate disinfec�on before or

a�er this system.

Installa�on must comply with any exis�ng State or Local Plumbing codes. Some Plumbing Codes require the installa�on of water filter

systems to be carried out by a licensed plumber.

For COLD water use only. Maximum temperature 38°C. Minimum temperature 2°C.

For internal use only.

The inlet water pressure to this water filter housing must not exceed 900kPa (130psi).

A cer�fied pressure limi�ng valve not exceeding 650kPa (95psi), dual check backflow preven�on valve must be installed on the inlet line

immediately preceding this water filter housing. This valve is included with this system (see Item 10 in Parts Sec�on).

We also recommend the installa�on of a water hammer protec�on device to protect the water filter housing and its installa�on. Where

water hammer problems exist, a water hammer protec�on device must be installed. Symptoms of water hammer can be noisy, shuttering

and banging pipes when water consuming appliances are opera�ng or taps are turned off. Should the system not be used for 2 days or more,

flush 1-2 litres of water through the system before consuming the water.

To ensure the high level of performance and protec�on provided from this water filter system, only use Bombora replacement cartridges

which have a maximum cartridge life of 12 months.

A�er installa�on, check the output water with a test strip and then test every 6-8 weeks a�erwards to establish your filter life based on your

average use. The TH reading should be below low range (less than 80PPM). If you get a higher reading than this on installa�on, call us to

discuss adjus�ng your bypass setting or restric�ng water flow further. Suggested filter cartridge change is 12 months or when the so�ening

capacity is diminished (over 80 PPM TH), whichever comes sooner.

bomborasupplies.com.au

1300 724 249

PART # C150KIT-FINEST