Deck Masters EDGEfast Инструкция по эксплуатации
Просмотреть онлайн или скачать pdf Инструкция по эксплуатации для Электроинструменты Deck Masters EDGEfast. Deck Masters EDGEfast 4 страницы. Hidden fastener decking system
Печатать страницуThe EDGEfast Decking System was designed & built for Professional Deck Builders.
This system should only be used by trained deck contractors.
WARNING:
All operators of this power tool should read and understand all tool labels, installation
manuals, owner's manuals, and packaging information before connecting the tool to an
air supply. It is the operator's responsibility to learn how to work with a power tool before
connecting the power supply. If an operator is unsure or uncomfortable using a power
tool,
STOP,
do not continue.
DANGER:
Failure to operate or work with power tools responsibly can result in serious injuries to the
operator, or anyone within the work area. Keep others out of the work area whenever
possible. No horseplay.
Operator and others nearby must wear
Use this tool for installing deck boards only, do not use the tool for anything other than
standard decking materials.
WARNING:
This tool has a trigger safety that is attached to the tool base pivot. The base must be place on
decking, that is over a joist or substrate. The base must be depressed in order to disengage
the safety and activate the trigger, to fire the tool.
WARNING:
Doing this will trigger the tool to fire a fastener, do this only when the tool is on a work
surface that is ready to be fastened.
WARNING:
Never pull the trigger unless the tool is on a work surface that is ready to be fastened.
Keep your hands and body away from the discharge area of the tool. Never point the tool at
yourself or others.
DANGER:
Do not use oxygen, combustible gases, or bottled gases as a power source for this tool as tool
may explode, possibly causing serious injury.
DANGER:
Do not use an air supply which can potentially exceed 200 psi.
DANGER:
Do not use the tool near highly flammable, combustible, or explosive gases, vapors, fumes,
fluids or any other highly flammable materials.
WARNING:
Connect the tool to a clean regulated air supply with a coupling that removes all pressure
from the tool when the coupling is disconnected.
WARNING:
Always disconnect the air supply, before making adjustments, servicing the tool, clearing
a jam, when tool is not in use, or when moving to a different work area.
Never use a tool that is leaking air, has missing or damaged parts. Always make sure
all screws and caps are tight.
Do not use the tool if the trigger is inoperable, broken or missing, do not alter the tool, or
safeties in any way.
safety glasses, ear protection
and a
hard hat.
2