DECKED ToolBox Ladder Bracket Установка - Страница 2

Просмотреть онлайн или скачать pdf Установка для Автомобильные аксессуары DECKED ToolBox Ladder Bracket. DECKED ToolBox Ladder Bracket 2 страницы.

CAB

• Check to see that the ladder pivot brackets are installed -

• Rest the folded ladder on a table or hard surface so that you can read the instructions on the bottom of the first rung.

• While holding the top rung, pull the bottom rung from the ladder assembly until both the bottom and middle rungs lock in place.

• Set the ladder on the ground vertically next to the passenger side of your Tool Box.

• Raise both arms and extend them up and over the edge of the Tool Box to meet with the mounting discs.

• Using a 5/32" hex wrench, install the hardware in the order shown, DETAIL A. Repeat on opposite side. Tighten until snug - DO NOT OVERTIGHTEN.

• Return the ladder to the Tool Box by collapsing the rungs and folding back into place.

USING THE LADDER:

STEP 1

"CLICK"

▼ WARNING DON'T DO THIS ▼

DECKED.COM | #DECKEDUSA | @DECKEDUSA

LADDER INSTALLATION

(orange in Detail A). If not, see previous page.

STEP 2

PLACE LADDER ON SOLID GROUND

WITH BOTH RUNGS LOCKED INTO

PLACE (LADDER STEPS 1-3). FAILURE

TO DO THIS COULD ALLOW LADDER

TO SWING INTO TRUCK AND CAUSE

DAMAGE TO THE VEHICLE

LADDER

BRACKET

NOTE: The ladder brackets must be facing down.

STEP 3

"CLICK" AGAIN

@DECKEDUSA | #DECKEDUSA

TOOLS NEEDED:

• 5/32" hex wrench

DETAIL A

POSITION LADDER

VERTICALLY TO

SOLID GROUND

WATCH LADDER INSTRUCTIONAL VIDEOS:

DECKED.COM/LADDER

RC618| v.3 | Page 2