Major tech MT767 Руководство по эксплуатации - Страница 4

Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Измерительные приборы Major tech MT767. Major tech MT767 12 страниц. 600a ac/dc clamp meter with ir thermometer

Печатать страницу

1. SAFETY

1.1. lnternational Safety Symbols

This symbol, adjacent to another symbol or terminal, indicates

the user must refer to the manual for further information.

This symbol, adjacent to a terminal, indicates that, under

normal use, hazardous voltages may be present.

Double insulation.

1.2. Safety Notes

• Do not exceed the maximum allowable input range of any function.

• Do not apply voltage to meter when resistance function is selected.

• Set the function switch OFF when the meter is not in use.

1.3. Warnings

• Set function switch to the appropriate position before measuring.

• When measuring volts do not switch to current/resistance modes.

• When changing ranges always disconnect the test leads from the circuit

under test.

• Do not exceed the maximum rated input limits.

1.4. Cautions

• Improper use of this meter can cause damage, shock, injury or death.

Read and understand this user manual before operating the meter.

• Always remove the test leads before replacing the battery.

• Inspect the condition of the test leads and the meter itself for any

damage before operating the meter. Repair or replace any damage

before use.

• Use great care when making measurements if the voltages are greater

than 25VAC RMS or 35VDC. These voltages are considered a shock

hazard.

• Remove the battery if the meter is to be stored for long periods.

• Always discharge capacitors and remove power from the device under

test before performing Diode, Resistance or Continuity tests.

• Voltage checks on electrical outlets can be difficult and misleading

because of the uncertainty of connection to the recessed electrical

contacts. Other means should be used to ensure that the terminals are

not "live".

• If the equipment is used in a manner not specified by the manufacturer,

the protection provided by the equipment may be impaired.