The oven lights are standard 40-watt appliance bulbs. They will
come on when the oven is operating in any cook mode. The oven
lights will not work during the Self-Cleaning
cycle and when the
selector knob is set to OFE
To Replace:
Before replacing, make sure the oven is off and cool.
1. Disconnect
power.
2. Turn the glass bulb cover in the back of the oven
counterclockwise
to remove.
3. Turn bulb counterclockwise
to remove from socket.
4. Replace bulb and bulb cover by turning clockwise.
5. Reconnect power.
For normal range use, it is not suggested to remove the oven
door. However, if removal is necessary, make sure the oven is off
and cool. Then, follow these instructions. The oven door is heavy.
To Remove:
1. Open oven door all the way.
2. Flip up the hinge latch on each side.
3=
4.
Close the oven door as far as it will shut.
Lift the oven door while holding both sides.
Continue to push the oven door closed and pull it away from
the oven door frame.
To Replace:
1. Insert both hanger arms into the door.
2. Open the oven door.
You should hear a "click" as the door is set into place.
3. Move the hinge levers back to the locked position. Check
that the door is free to open and close. If it is not, repeat the
removal and installation procedures.
TROUBLESHOOTING
Try the solutions suggested here first in order to avoid the
cost of an unnecessary service call.
Nothing will operate
•
Has a household fuse blown, or has a circuit breaker
tripped?
Replace the fuse or reset the circuit breaker. If the problem
continues, call an electrician.
Is the appliance
wired properly?
See Installation Instructions.
Oven will not operate
Is the electronic oven control set correctly?
See "Electronic Oven Control" section.
On double oven models, has the correct oven been
selected?
Make sure to set the correct controls for the oven (upper or
lower) you want to use.
On double oven models, is one oven self-cleaning?
When one oven is self-cleaning
the other oven cannot be set
or turned on.
Cooling fan runs during baking, broiling or cleaning
•
It is normal for the fan to automatically
run while the oven is in
use to cool the electronic control, and may run for up to
45 minutes after oven has been turned off.
Display shows messages
Is the display showing "PF"
There has been a power failure. Clear the display. See
"Display(s)" section. Set the clock, if needed. See "Clock"
section.
Is the display showing a letter followed
by a number?
Clear the display. See "Display(s)" section. If it reappears, call
for service. See "Assistance
or Service" section.
Self-Cleaning cycle will not operate
•
Is the oven door open?
Close the oven door all the way.
•
Has the function
been entered?
See "Self-Cleaning
Cycle" section.
•
Has a delay start Self-Clean
cycle been set?
See "Self-Cleaning
Cycle" section.
•
Has a delay start been set?
See "Timed Cooking" section.
•
On double oven models, is one oven self-cleaning?
When one oven is self-cleaning,
the other oven cannot be set
to self-clean.
12
Печатать страницу