Britannia 70CM Инструкции пользователя - Страница 8
Просмотреть онлайн или скачать pdf Инструкции пользователя для Вентиляционная вытяжка Britannia 70CM. Britannia 70CM 13 страниц. Built-in 70cm with asc canopy hood
Печатать страницу
odours, smoke and gas present in the kitchen.
C Display C indicates the automatic operation of the sensor (the letter "A" appears); - indicates
the motor speed selected automatically by the sensor; and indicates the filter alarm whenever
the central segment is illuminated or flashing.
D Button D will decrease the speed of the motor. After approximately one minute the hood
resumes automatic operation at the speed set by the sensor. If the filter alarm indicator is on
and button D is pressed, the alarm is RESET, and the counting of the operation hours begins
again.
E Button E will increase the speed of the motor. After approximately one minute the hood
resumes automatic operation at the speed set by the sensor.
Modification of the sensor sensitivity
Sensitivity of the sensor can be modified as follows:
1. Stop the hood by pressing Button B.
2. Simultaneously press keys D and E. The sensitivity setting will appear on the display.
3. Press keys D or E to increase or decrease sensitivity.
1 = minimum setting, 9 = maximum setting
Whenever the power supply is interrupted, the sensor will resume operation at setting 5.
WARNING: DO NOT USE SILICONE-BASED PRODUCTS NEAR THE HOOD AS THIS MAY
DAMAGE THE SENSOR.
Operation of the hood without the automatic sensor:
Disable the sensor by pressing button B so that the display shows blank.
A Button A turns the lights on/off.
C Display C indicates the motor speed selected (1 to 4) and indicates the filter alarm whenever
the central segment is illuminated or flashing.
D Button D will decrease the speed of the motor and will stop it if speed zero is selected. If the
number is flashing, this indicates that the Timer is in use. If the filter alarm indicator is on and
button D is pressed, the alarm is RESET, and the counting of the operation hours begins
again.
E Button E will enable and increase the speed of the motor. After approximately one minute
the hood resumes automatic operation at the speed set by the sensor. Keeping this button
pressed down for a few seconds enables the Timer.
Using the timer when not in automatic mode:
To enable the timer, keep button B pressed down for a few seconds. The motor will continue to
run at the selected speed for 5 minutes and then stop.
To disable the timer, hold button B down for a few seconds.
Cleaning and maintenance
Always turn off the electricity supply before conducting any cleaning or maintenance. To remove
the metal grease filters for cleaning, see figure 4 on page 10. These can be cleaned by hand in
hot soapy water or clean in a dishwasher. Use a reputable stainless steel cleaner for cleaning the
exterior of the hood and follow the manufacturer's instructions. If your hood is being used on
filtering mode refer to figure 7 to change the charcoal filters. Do not use silicon based products
near the hood.
8 of 11