IKEA LAGAN Руководство - Страница 12

Печатать страницу

ENGLISH

Cleaning and maintenance

ATTENTION: Always unplug the appliance when cleaning it and

when performing maintenance work. Do not use flammable

liquids to clean the machine.

Cleaning the dishwasher

Any marks on the inside of the appliance may

be removed using a cloth dampened with water

anda little vinegar.

The external surfaces of the machine and the

control panel can be cleaned using a non-

abrasive cloth which has been dampened with

water. Do not use solvents or abrasive products.

Preventing unpleasant odours

Always keep the door of the appliance ajar in order to avoid

moisture from forming and being trapped inside the machine.

Clean the seals around the door and detergent dispensers

regularly using a damp sponge. This will avoid food becoming

trapped in the seals, which is the main cause behind the

formation of unpleasant odours.

Cheking the water supply hose

Check the inlet hose regularly for brittleness and cracks. If

damaged, replace it by a new hose available through our After-

Sales Service or your specialist dealer. Depending on the hose

type:

If the inlet hose has a transparent coating, periodically check

if the colour intensifies locally. If yes, the hose may have a leak

and should be replaced.

For water stop hoses: check the small safety valve inspection

window (see arrow). If it is red, the water stop function was

triggered, and the hose must be replaced by a new one.

For unscrewing this hose, press the release button while

unscrewing the hose.

Cleaning the water inlet hose

If the water hoses are new or have not been used for an

extended period of time, let the water run to make sure it is

clear and free of impurities before performing the necessary

connections. If this precaution is not taken, the water inlet could

become blocked and damage the dishwasher.

Cleaning the filter assembly

Regularly clean the filter assembly so that the filters do not clog

and that the waste water flows away correctly.

Using dishwasher with clogged filters or foreign objects inside fil-

tration system or sprayarms may cause unit malfunction resulting

in lose of performance, noisy work or higher resources usage.

The filter assembly consists of three filters which remove food

residues from the washing water and then recirculate the water.

The dishwasher must not be used without filters or if the

filter is loose.

At least once per month or after each 30 cycles, check the filter as-

sembly and if necessary clean it thoroughly under running water,

using a non-metallic brush and following the instructions below:

1. Turn the cylindrical filter A in an anti-clockwise direction and

pull it out (Fig 1).

2. Remove the cup filter B by exerting a slight pressure on the

side flaps (Fig 2).

3. Slide out the stainless-steel plate filter C (Fig 3).

4. In case you find foreign objects (such as broken glass,

porcelain, bones, fruit seeds etc.) please remove them

carefully.

5. Inspect the trap and remove any food residues. NEVER

REMOVE the wash-cycle pump protection (black detail) (Fig 4).

After cleaning the filters, replace the filter assembly and fix it in

position correctly; this is essential for maintaining the efficient

operation of the dishwasher.

Cleaning the spray arms

On occasions, food residue may become encrusted onto the

spray arms and

block the holes

used to spray the

water. It is therefore

recommended that

you check the arms

from time to time

and clean them with

a small non-metallic

brush.

To remove the upper

spray arm, turn the

plastic locking ring in a

clockwise direction. The upper spray arm should be replaced so

that the side with the greater number of holes is facing

upwards.

The lower spray arm may be

removed by pulling it upwards

and rotating it anti-clockwise.