IKEA LAGAN Руководство - Страница 16

Печатать страницу

ENGLISH

Installation

ATTENTION: If the appliance must be moved at any time, keep

it in an upright position; if absolutely necessary, it may be tilted

onto its back.

Connecting the water supply

Adaptation of the water supply for installation should only be

performed by a qualified technician.

The water inlet and outlet hoses may be positioned towards the

right or the left in order to achieve the best possible installation.

Make sure the dishwasher does not bend or squash the hoses.

Connecting the water inlet hose

• Run the water until it is perfectly clear.

• Screw the inlet hose tightly into position and turn on the tap.

If the inlet hose is not long enough, contact a specialist store or

an authorised technician.

The water pressure must be within the values indicated in the

Technical Data table - otherwise the dishwasher may be function

properly.

Make sure the hose is not bent or compressed.

Specifications for the connection of the water supply hose:

Water supply

Water intake

Power of water pressure

Connecting the water outlet hose

Connect the outlet hose to a drain duct with a minimum

diameter of 2 cm A.

The outlet hose connection must be at a height ranging from

40 to 80 cm from the floor or surface where the dishwasher

rests.

Before connecting the water outlet hose to the sink drain,

remove the plastic plug B.

cold or hot (max. 60°C)

3/4"

0.05 ÷ 1 MPa (0.5 ÷ 10 bar)

7.25 – 145 psi

MAX 80 cm

MIN 40 cm

Electrical connection

WARNING: Under no circumstances should the water inlet

hose be cut as it contains live electrical parts.

Before inserting the plug into the electrical socket, make sure

that:

• The socket is earth and complies with current regulations;

• The socket can

withstand the maximum load of the

appliance as shown on the data plate located on the inside of

the door (see PRODUCT DESCRIPTION).

• The power supply voltage falls within the values indicated on

the data plate on the inside of the door.

• The socket is compatible with the plug of the appliance.

If this is not the case, ask an authorised service only to replace

the certified power cord with a correct plug dedicated for this

appliance (see AFTER-SALES SERVICE). Do not use extension cab-

lesor multiple sockets or not authorized power cords with plugs.

Once the appliance has been installed, the power supply cable

and the electrical socket should be easily accessible.

The cable should not be bent or compressed.

If the power supply cable is damaged, have it replaced by the

manufacturer or its authorised Technical Assistance Service in

order to prevent all potential hazards.

The Company shall not be held responsible for any incidents, if

these regulations are not observed.

Positioning and levelling

1. Position the dishwasher on a level sturdy floor. If the floor is

uneven, the front feet of the appliance may be adjusted until

it reaches a horizontal position. If the appliance is levelled

correctly, it will be more stable and much less likely to move

or cause vibrations and noise while it is operating.

2. Before recessing the dishwasher, stick the adhesive transparent

strip under the wooden shelf in order to protect it from any

condensation which may form.

3. Place the dishwasher so that its sides or back panel are in

contact with the adjacent cabinets or the wall. This appliance

can also be recessed under a single worktop.

4. To adjust the height of the rear foot, turn the red hexagonal

bushing on the lower central part at the front of the

dishwasher using a hexagonal spanner with an opening of 8

mm. Turn the spanner in a clockwise direction to increase the

height and in an anticlockwise direction to decrease it.

DIMENSIONS AND CAPACITY:

Width

Height

Depth

Capacity

598 mm

820 mm

555 mm

14 standard place-settings