CenturionPro DBT 3 Руководство пользователя - Страница 8
Просмотреть онлайн или скачать pdf Руководство пользователя для Промышленное оборудование CenturionPro DBT 3. CenturionPro DBT 3 16 страниц. With variable speed control
Печатать страницу
LOAD
Remove clear Tumbler Lid from front of
Tumbler. Hold drum and pull out Plunger
and pivot drum into a vertical and upward
facing position, replace Plunger. Load dried,
prepped, untrimmed plant material into the
Tumbler. For best efficiency, fill Tumbler 40-
60% full and run batches of similar material.
Empty Trim Tray:
Lift the Tray Stop on the front of the machine to release the Trim Tray. Slide Trim Tray out of slots, empty tray and replace.
IMPORTANT NOTE:
TRIM TRAY SERVES AS A COLLECTION MECHANISM AND AS A SAFETY GUARD. MACHINE SHOULD NOT BE RUN
WITHOUT TRIM TRAY IN PLACE AND TABS ORIENTED IN THE VERTICAL POSITION.
SERVICING YOUR TRIMMER
Proper maintenance is essential for safe, economical, and trouble free operation.
Other service tasks that are more difficult, or require special tools, are best handled by professionals and are normally performed by a Centurion Pro technician or other qualified mechanic.
The maintenance schedule applies to normal operating conditions. If you operate your trimmer under severe conditions, such as sustained high load or high temperature operation, or use
it in unusually wet or dusty conditions, consult your servicing dealer for recommendations applicable to your individual needs and use.
Remember that an authorized Centurion Pro servicing dealer knows your trimmer best and is fully equipped to maintain and repair it. To ensure the best quality and reliability, use only new,
Centurion Pro parts or their equivalents for repair and replacement.
NOTICE: Improper maintenance, or failure to correct a problem before operation, can cause a malfunction which can cause serious injury
or death. Always follow the inspection and maintenance recommendations and schedules in this owner's manual.
IMPORTANT NOTE:
MOTOR & SPEED CONTROL BOX ARE NOT WATERPROOF.
DO NOT GET WET. REMOVE WHEN NECESSARY
8
1 855 535 0558
RUN
Re-apply clear Tumbler Lid. Pull out Plunger
and pivot drum into a horizontal position, re-
place Plunger. Tighten Blade Sheet as required.
Turn machine ON and allow to run for 1-15
minutes. Check material every 2-5 minutes. For
a closer trim, continue running the DBT Model
3 until desired trim is accomplished.
cprosolutions.com
TRIMMING PLANT MATERIAL
EMPTY
Once desired trim is accomplished,
remove Trim Tray & Tumbler Lid, position
separate container (not included) to capture
processed material, pull out Plunger and
pivot drum to a downward facing position.
Processed material will be deposited in the
container when correctly positioned.