AGUZZO Streamline S90L534 Инструкции по установке - Страница 2
Просмотреть онлайн или скачать pdf Инструкции по установке для Нагреватель AGUZZO Streamline S90L534. AGUZZO Streamline S90L534 5 страниц. 304 stainless steel heated towel rail
Печатать страницуKey Specifications
Construction: 304 Stainless Steel – corrosion protection – no chrome
Electrical - Tested and certified to comply with AS/NZ: 60335 and c-tick requirements
IP55 Rated – water splash and spray proof
Power supply – 220-240 Vac, 50/60Hz
Important safeguards
§ Eliminate choking and suffocation hazards for young children by removing and safely
discarding all protective packaging and the protetive cover on the power plug
§ This appliance operates at a temperature that is hot but not scalding on touch (up to
55°C). Rises in ambient temerature and the insulation effect of towels can cause the
operating temperature to rise. Young children and infirm persons should be supervised
near this appliance
§ Do NOT use this towel rail to dry damp or wet clothing or articles that have been in
contact with oil, petroleum based products, or dry cleaning fluids.
§ Use this appliance ONLY on the voltage specified on its electrical specification label
§ Do NOT use this appliance other than for its intended use
§ IPX5 rated to withstand water splashes and sprays. Do NOT immerse in liquid
§ Do NOT allow the power supply cord to come into contact with any heated surfaces.
Installation requirements
§ Carefully read all instructions before installation and operation
§ If you are hard-wiring or connecting to a switch/controller this appliance MUST be
installed by a qualified and licenced electrician in accordance with relevant wiring rules
(AS/NZS 3000:2000 in Australia and New Zealand)
§ It MUST be installed so the bottom rail is at least 600mm from the floor.
§ It MUST be installed at least 1.7m from combustible materials such as drapes and
furnishings
§ The appliance is supplied with an earthed 3-core supply cord and plug. This cord and
plug MUST be positioned so it is not subject to splashing water or ingress of msoiture.
§ Install with a suitable switch or controller:
- Plug into a power point with a switch
- Hardwire to a wall switch
- Hardwire to a controller (such as a timer switch or thermostat switch)
§ Do NOT install or operate with a damaged cord or plug.
§ Do NOT cover the cord and ensure it is arranged so it does not pose a risk
§ Do NOT install outdoors
:
IMPORTANT
Retain
this instruction booklet
for future reference