IKEA ID5HHEXWS01 Инструкции пользователя - Страница 3

Просмотреть онлайн или скачать pdf Инструкции пользователя для Холодильник IKEA ID5HHEXWS01. IKEA ID5HHEXWS01 28 страниц.

Печатать страницу

Explosion Hazard

Keep flammable

materials

and vapors, such as

gasoline,

away from refrigerator.

Failure to do so can result in death, explosion, or fire.

To ensure proper ventilation for your refrigerator, allow for V2"

(1.25 cm) space on each side and at the top. When installing your

refrigerator next to a fixed wall, leave 2" (5.08 cm) minimum on

each side (depending on your model) to allow for the door to

swing open. If your refrigerator has an ice maker, allow extra

space at the back for the water line connections.

-_ /41

1/2" (1.25 cm)//t

,, - if!

2" (5.08 cm)

NOTES:

•

It is recommended

that you do not install the refrigerator near

an oven, radiator, or other heat source. Do not install in a

location where the temperature will fall below 55°F (13°C).

Normal minimum cabinet cut-out width required for product

installation is 36" (91.44 cm). However, if the product is placed

against an extended wall and the ability to remove the crisper

pans is desired, an additional 18" (45.72 cm) of cabinet width

is required, so a total cabinet opening width of 54"

(137.16 cm)is recommended.

Electrical Shock Hazard

Plug into a grounded

3 prong outlet.

Do not remove ground prong.

Do not use an adapter.

Do not use an extension

cord.

Failure to follow these instructions can result in death,

fire, or electrical

shock.

Before you move your refrigerator into its final location, it is

important to make sure you have the proper electrical connection.

Recommended

Grounding

Method

A 115 Volt, 60 Hz., AC only, 15- or 20-amp fused, grounded

electrical supply is required. It is recommended

that a separate

circuit serving only your refrigerator be provided. Use an outlet

that cannot be turned off by a switch. Do not use an

extension cord.

NOTE: Before performing any type of installation, cleaning, or

removing a light bulb, turn the control (Thermostat, Refrigerator or

Freezer Control depending on the model) to OFF and then

disconnect the refrigerator from the electrical source. When you

are finished, reconnect the refrigerator to the electrical source and

reset the control (Thermostat, Refrigerator or Freezer Control

depending on the model) to the desired setting. See "Using the

Controls."

!_e[ e _i' "'

pp/y Ii®qui[®me ' Is

Gather the required tools and parts before starting installation.

Read and follow the instructions

provided with any tools listed

here.

TOOLS NEEDED:

•

Flat-blade screwdriver

•

V4" Nut driver

•

7/_6"and V2" Open-end or two

•

V4" Drill bit

adjustable wrenches

•

Cordless drill

NOTE: Your refrigerator dealer has a kit available with a V4"

(6.35 mm) saddle-type

shutoff valve, a union, and copper tubing.

Before purchasing, make sure a saddle-type

valve complies with

your local plumbing codes. Do not use a piercing-type

or 346"

(4.76 mm) saddle valve which reduces water flow and clogs more

easily.

IMPORTANT:

•

All installations must meet local plumbing code requirements.

•

Use copper tubing and check for leaks. Install copper tubing

only in areas where the household temperatures will remain

above freezing.