Decofire Milano Series Инструкции по монтажу, безопасности и эксплуатации - Страница 11
Просмотреть онлайн или скачать pdf Инструкции по монтажу, безопасности и эксплуатации для Открытый камин Decofire Milano Series. Decofire Milano Series 17 страниц.
Печатать страницуOPERATION
Appliance, Gas Controls and Burner
Inspect all major components on the appliance:
• Check the burner, glass tube and reflector for any damage or build up of carbon, spider webs or nests etc.
• Check that the wire guard is secured and undamaged.
• Check the appliance controls - (flame adjustment control and starter button) - the flame adjustment control should rotate
smoothly and the starter button, when pressed, should cause a spark to occur at the burner ignition probe.
• Ensure the ignition probe is clear of dust or debris.
Gas Hose & Regulator - Gas Line Connections
• Inspect the appliance gas hose and regulator for abrasion, cuts or other damage. If there are signs of wear, abrasion or
damage, you must replace the hose and regulator.
• If the gas hose / regulator has been disconnected from the appliance for a period of time - inspect the POL connector to
ensure it is free of any dirt, spider webs or nests etc. If not cleared, these elements can cause a blockage that will prevent
the appliance from functioning.
Gas Cylinder & Cylinder Valve
• Inspect the gas cylinder and cylinder valve for any signs of wear or damage.
• The gas cylinder should be clean and show no signs of rust or dents. If the cylinder is corroded or has sustained a dent it
will need to be checked at an authorised cylinder inspection station. (Or swap over your cylinder for a freshly filled one at
your nearest cylinder exchange retailer).
• If the gas cylinder has been disconnected from the appliance for a period of time - inspect the cylinder valve / outlet to
ensure it is free of any dirt, spider webs or nests etc. If not cleared, these elements can cause a blockage that will prevent
the appliance from functioning.
Gas Leak Test
• Before using the appliance each time, it is advisable to
perform a leak test on each gas line connection.
• Prior to performing a leak test be sure there are no live
ignition sources present such as a naked flame or pilot
light for another gas appliance.
• Never ever check for gas leaks with a naked flame.
Leak Test Procedure
1. Connect the appliance hose & regulator to the gas
cylinder and make sure the valve on the gas cylinder is
turned off.
2. Check that the gas control on the appliance is turned to
the 'OFF' position.
3. Brush a mixture of detergent and water on all
connections. including the Hose, Regulator, POL
Connection, Cylinder Valve.
4. Turn the gas cylinder valve on. If bubbles form on any
connection point along the gas line, this is an indication
that a leak is present.
5. If you smell gas or a leak is discovered, turn the gas
cylinder valve off, disconnect the regulator from the gas
cylinder and do not use the appliance until the leak is
repaired.
Leak test the gas
gas hose and each
connection point
Bubbles indicate
a leak present
Page 11