decoflame DENVER E-RIBBON BASIC 920 Краткое руководство по эксплуатации - Страница 3
Просмотреть онлайн или скачать pdf Краткое руководство по эксплуатации для Крытый камин decoflame DENVER E-RIBBON BASIC 920. decoflame DENVER E-RIBBON BASIC 920 3 страницы.
Печатать страницу
Filament
Fuel tank
Operating:
Step 1
Turn on the electronics of your Denver e-Ribbon Basic™ by pressing the button.
Step 2
Fill in the right amount of bioethanol in the fuel tank by verifying the level on the fuel level indicator.
Step 3
To ignition the fireplace. Press the
After about 3 minutes, the first flames will appear around the centre of the flame tray.
Step 4
When the filament is no longer red (approx. 10 min) it is possible to adjust the flames.
Step 5
To switch off the fire at any time – also during the warming-up phase – press the button on the
control panel. The flames will disappear within a few minutes.
1. Download and install the Decoflame App
corresponding to your smart device's operat-
ing system. For more information go to:
decoflame.com.
4. Once you have selected your fireplace, you
can turn it on by pressing 'START'. If the fire-
place has already been turned on using the
control panel, you can now monitor the fuel
level and the consumption.
button on the control panel.
Installation of Decoflame App to the Denver e-Ribbon Basic burner
2. In order to pair your fireplace with your
smart device, start the fireplace by pressing
the 'ON' button.
Start the App and choose your fireplace.
Insert the code from YOUR rating plate, like
the one highlighted above.
5. For the 'Turn Off Timer' press the clock icon
in the lower right corner. To adjust the remain-
ing time, slide the dot to the left and right and
select 'SET TIMER'. The remainig burning
time can be changed by repeating the above
mentioned steps. To cancel the timer select
'CLEAR TIMER'.
www.decoflame.com
Control Panel
On / Off
Adjust the flame level down
3. Once your device is paired, the fireplace
should be visible on the app. You are now
able to change the name of the fireplace.
Note: You are able to pair more than one fire-
place like described in the step nr. 2 and give
them different names.
6. For adjusting the flame intesity, select the
desired level on the left side of the screen.
(1-lowest, 6-highest)
Should there not be enough fuel for the select-
ed burning time - the fireplace will shut down
automatically.
Select 'STOP' to turn off the fireplace.
Service USB
Flame level indicator
1-5 + ECO-Wave
Fuel level indicator
START/STOP the fireplace
Adjust the flame level up
Use the supplied remote
control or download the
Decoflame App to your
mobile device for con-
trolling the biofireplace.