IKEA NEDISAD ST18 Руководство - Страница 40
Просмотреть онлайн или скачать pdf Руководство для Холодильник IKEA NEDISAD ST18. IKEA NEDISAD ST18 48 страниц.
Печатать страницу
ENGLISH
Problem
The appliance is noisy.
The lamp does not work.
The compressor operates
continually.
The compressor does not start
immediately after restarting.
Water flows on the floor.
The temperature in the
appliance is too low/too high.
The temperature in the
appliance is too low/too high.
Possible cause
The appliance is not supported
properly.
The lamp is defective.
Many food products were put in
at the same time.
The room temperature is too high.
Food products placed in the
appliance were too warm.
The door is not closed correctly.
This is normal. No error has
occurred.
Food products prevent that water
flows into the water collector.
The melting water outlet is not
connected to the evaporative tray
above the compressor.
The door is not closed correctly.
The food products' temperature is
too high.
Many food products are stored at
the same time.
The door has been opened often.
There is no cold air circulation in
the appliance.
Solution
Check if the appliance
stands stable.
Use instruction below to
change the lamp
Wait some hours and then
check the temperature
again.
Refer to climate class chart
on the rating plate.
Allow food products to cool
to room temperature before
storing.
Refer to "Closing the door".
Switch on the appliance
after 10 min break.
Make sure that food
products do not touch the
rear plate.
Attach the melting water
outlet to the evaporative
tray.
Refer to "Closing the door".
Let the food products
temperature decrease to
room temperature before
storage.
Store less food products at
the same time.
Open the door only if
necessary.
Make sure that the cold air
freely circulates inside the
appliance
40