IKEA FORDELAKTIG Руководство - Страница 23
Просмотреть онлайн или скачать pdf Руководство для Варочная панель IKEA FORDELAKTIG. IKEA FORDELAKTIG 32 страницы.
Также для IKEA FORDELAKTIG: Руководство (32 страниц)
Печатать страницу
ENGLISH
Troubleshooting
Error code
Description
No Function
ER and 03 flashes
ER 03 and
alternately.
continuous
Control panel
tone or
turns off after 10
sec.
ER and 03 flashes
ER 03 and
alternately.
continuous
Control panel
tone
turns off after
Extractor
10 sec. Extractor
control panel
motor is still on.
ER and 47 flashes
alternately.
ER47
Control panel turns
off after 10 sec.
ER and 06 flashes
alternately.
E/6
Control panel turns
off after 10 sec.
ER20
ER22
ER30
ER36
Disconnect the hob extractor from the power supply.
ER39
Wait a few seconds then reconnect the hob extractor to the power supply.
U400
If the problem persists,please contact After Sales Service and specify the error code that
E/2
appears on the display.
E/A
E/4
E/7
E/8
E/9
If there is a fault try to solve the problem by
following the troubleshooting guidelines. If the
problem cannot be solved contact After Sales
Service. You can find a full list of IKEA
appointed contacts at the end of this user
manual.
Possible cause of error
Wrong connection to the
mains or shortcircuit
Continuous sensor activation
detected. Water or cookware
on the glass over the control
panel.
Continuous sensor activation
detected. Water or cookware
on the glass over control
panel of the extractor.
Error in connecting the power cable
on the product side
Deviations of the mains power
supply in the frequency or voltage
level. Solar-powered inverters could
cause an E6 Error in case it creates
a ripple on the mains voltage (high
frequency overlie).
Remedy
Disconnect the hob extractor from the
power supply.
Adjust the power supply connection
according to "ELECTRICAL
CONNECTION" paragraph if needed.
If error persists, please contact After
Sales Service and specify the problem.
Remove water or cookware from glass
and control panel.
Turn off the hob extractor
Remove water or cookware from glass
and control panel.
Touch again the control panel of the
extractor.
Disconnect the hob extractor from the power
supply. Adjust the power supply connection
according to "ELECTRICAL CONNECTION"
paragraph if needed with special attention to
correct fixation of the shunts on the product
side. If error persists, please contact After
Sales Service and specify the problem.
As soon as the mains power supply
parameters recover to normal condition, the
E6 Error disappears. If error persists, please
contact After Sales Service and specify the
problem.
If you operate the appliance wrongly, or the
installation was not carried out by an
authorised installer, the visit from the After
Sales Service technician or dealer will not be
free of charge, even during the warranty
period.
23