Century UK Neon Blaze CP V2.4G Руководство пользователя - Страница 5
Просмотреть онлайн или скачать pdf Руководство пользователя для Игрушка Century UK Neon Blaze CP V2.4G. Century UK Neon Blaze CP V2.4G 18 страниц.
Печатать страницу1. Because the helicopter is operated by radio control, it is important to make sure you are always using fresh and/ or fully charged batteries.
Never allow the batteries to run low, or you could lose control of the helicopter.
2. Do not allow any of the electrical components to get wet. Otherwise electrical damage may occur.
3. You should complete a successful range check of your radio equipment prior to each new day of flying, or prior to the first flight of a new
or repaired model.
4. If the helicopter gets dirty, don't use any solvents to clean it. Solvents will damage the plastic and composite parts.
5. Always turn on the transmitter before plugging in the flight battery and always unplug the flight battery before turning off the transmitter.
6. Never cut the receiver antenna shorter or you could lose control of the helicopter during flight.
7. When flying the helicopter, please make sure that the transmitter antenna is completely extended and is pointed up toward the sky, not
down toward the ground.
Don't fly helicopter at the places with these signs
The code pairing instruction for CUK-2601:
1. The usage of 2.4G technology is prompter in reaction, more sensitive in operation, and stronger in anti-interference.
2. The methods for automatic scanning, code pairing and ID allocation are shown as below :
A. Push the throttle stick to the lowest position and turn on the transmitter, and then the power indicator will flash ( Note: never move any
control sticks when it is flashing).
B. The receiver LED will flash swiftly as soon as the battery is connected to the receiver, and will get a solid light 1-3 seconds later (Note: Do move
the right control stick when it is having a solid light). When the power indicator of the transmitter has stopped flashing to recover to the state of
power indication, the codes have been matched successfully, and you can fly the helicopter.
Note: It will take about 10 seconds for the code pairing. If code pairing is failed, please re-turn on the transmitter to match the code again. Please
don't have the codes paired simultaneously when a few of people are flying their helicopters in the same field.
Cautions
Transmitter Features
4