KitchenAid KGCT305EBL0 Руководство по установке - Страница 2
Просмотреть онлайн или скачать pdf Руководство по установке для Варочная панель KitchenAid KGCT305EBL0. KitchenAid KGCT305EBL0 10 страниц. Sealed burner glass cooktops
Печатать страницу
30" (76.2cm) Cooktop
30" (76.2cm) min. base cabinet
is required. If
cabinet has a drawer, a 3-l/2" (8.9cm) depth
clearance from the countertop to the top of the
drawer (or other obstruction)
in base cabinet is
required.
36" (91.4cm) Cooktop
36" (91.4cm) min. base cabinet
is required.
If
cabinet has a drawer, a 3-l/2" (8.9cm) depth
clearance from the countertop to the top of the
drawer (or other obstruction)
in base cabinet is
required.
It is the customer's
responsibility:
l
To contact
a qualified
electrical
installer.
l
To assure that electrical
installation
is
adequate
and in conformance
with
National
Electrical
Code, ANSVNFPA
70
-
latest edition**,
or Canadian
Electrical
Code, C22.1 -1982 and C22.2 No. 01982
(or latest edition)***
and all local codes
and ordinances.
Fire Hazard
Do Not obstruct
the flow of combustion
and ventilation
air.
Injury Hazard
To eliminate
the risk of burns or fire, avoid
installing
cabinet
storage above the
cooking
surface.
If cabinets
are already
installed,
reduce the hazard of reaching
over a heated cooking
surface by installing
a range hood. The range hood should
extend a minimum
of 5 inches (12.7cm) oui
from the bottom front of the cabinets.
Reaching
over a heated cooking
surface
could result in a serious
burn or other
personal
injury.
Electrical
Shock Hazard
Take special
care when drilling
holes into
the wall for electrical
wiring.
Electrical
wires may be concealed
behind the wall
covering.
Failure to follow this instruction
could
result in death, fire, or electrical
shock.
I
For 30" (76.2cm) cooktop - 30" (76.2cm)
min. cabinet width above cooktop
For 36" (91.4cm) cooktop - 36" (91.4cm)
min. cabinet width above cooktop
1
13"
(33.0cm)
max.
-
I
See Note" for
minimum
clearances
*
16" (45.7cm) min. clearance
upper cabinet to countertop
-4
4'
-7
(
=-r
Burner box
l
Note: 30" (76.2cm) min. when bottom
of wood or
metal
cabinet is protected by not less than l/4"
(.6cm) flame retardant millboard
covered
with
not less than No. 28 MSG sheet steel, 0.015"
(.04cm)
stainless steel, 0.024" (.06cm) aluminum
or 0.020" (.05cm) copper.
36" (91.4cm) min. clearance between the top of
the cooking
platform and the bottom of an
unprotected wood or metal sheet.
LB,I
(1.9cm)
min.
30" (76.2cm)
cooktop:
A
l?-15/16"
(48.1cm)
A
l?-15116"
(48.1cm)
mm. opening
depth
mm. openmg
depth
B
27-M 6" (69.1 cm)
min. opening
width
B
33-7/l 6" (84.8cm)
min. opening
width
C
2-518" (6.7cm) min.
C
2-6/8" (6.7cm) min.
cabinet space to
backsplash or
cabinet space to
vertical
wall
backsplash or
vertical wall
D
5-114" (13.3cm)
min. cabinet
space
D
5-l/4"
(13.3cm)
min. cabinet
both sides of
space both sides
cooktop
from a
of cooktop
from a
combustible
combustible
surface
surface
Before you start...
WARNING:
If the information
in this manual
is not followed
exactly, a fire or explosion
may result causing
property
damage,
personal
injury or
death.
-
Do Not store or use gasoline
or other flammable
vapors
and liquids
in the vicinity
of
this or any other appliance.
-WHAT
TO DO IF YOU SMELL
GAS
l
Do Not try to light any
appliance.
l
Do Not touch any electrical
switch;
do not use any phone
in your building.
l
Immediately
call your gas
supplier
from a neighbor's
phone.
Follow the gas
supplier's
instructions.
l
If you cannot
reach your gas
supplier,
call the fire
department.
-
Installation
and service
must
be performed
by a qualified
installer,
service
agency
or
the gas supplier.
Important:
Observe
all governing
codes and
ordinances.
Proper installation
is your responsibility.
Make
sure you have everything
necessary for correct
installation.
It is the responsibility
of the installer
to comply with the installation clearances
specified on the model/serial
rating plate. The
model/serial
rating plate can be found on the
underside of the cooktop burner box.
Check location
where cooktop will be installed.
The location should be away from strong draft
areas, such as windows. The cooktop should be
located for convenient
use in the kitchen.
ALL OPENINGS
IN THE WALL OR FLOOR
WHERE THE COOKTOP
IS TO BE INSTALLED
MUST BE SEALED.
Grounded
electrical
outlet is required. See
"Electrical requirements."
Proper gas supply
connection
must be
available.
See "Gas supply requirements."
Note: The sealed gas cooktop is manufactured
for use with NATURAL gas. Conversion
to L.P.
gas can be made with Kit No. 4173627, available
from your KitchenAid dealer or authorized
parts
distributor.
Countertop
opening
dimensions
that are
shown must be used. Given dimensions
provide
required 0" (Ocm) clearance.
Cabinet
construction:
This appliance
is
designed for use in a base cabinet with a depth
of 24" (61cm). The maximum depth for overhead
cabinets is 13" (33cm). The minimum vertical
clearance between the cooking surface and the
overhead cabinets is 30" (76.2cm). Overhead
cabinets installed at either side of the appliance
must be a minimum of 18" (45.7cm) above the
cooking surface. The minimum distance between
the front edge of the countertop and the front
edge of the cooktop is 314" (1.9cm). The
minimum horizontal distance between the
overhead cabinets above the appliance are
shown for your model number.
New installations
- follow minimum
dimensions given.
Replacement
installations
-
Be sure that front
edge of cooktop is at least 1 -l/2" (3.8cm) back
from front edge of countertop.
When installing
cooktop
over a built-under
oven. Do Not fasten cooktop to counter-top with
clamps. Cooktop then will be easy to remove if
servicing is ever necessary.
**National
Fire Protection
Association
Batterymarch
Park
Quincy,
Massachusetts
02269
***Canadian
Standard
Association
178 Rexdale
Boulevard
Etobicoke,
Ontario
M9W 1 R3
Minimum
distance
to nearest side and
rear combustible
surface
above
countertop
Panel A