ENGLISH
2. Press + or - to set the Minute Minder. At
first the time is calculated in minutes
and seconds. When the time you set is
longer than 60 minutes, the symbol
comes on in the display. The appliance
then calculates the time in hours and
minutes.
3. The Minute Minder starts automatically
after five seconds.
4. When the set time ends, the acoustic
signal sounds for two minutes. 00:00
and
flash in the display. Press a but-
ton to stop the signal.
Using the accessories
Warning! Refer to the Safety chapters.
Core temperature sensor
The core temperature sensor measures the
core temperature of the meat. When the
meat is at the set temperature, the appli-
ance deactivates.
There are two temperatures to be set:
• The oven temperature.
• The core temperature. Refer to the values
in the table.
Recommended core temperatures
50 °C
60 °C
70 °C
Important! Only use the core temperature
sensor supplied with the appliance, or
genuine replacement parts.
1. Set the oven function and the oven tem-
perature.
2. Put the tip of the core temperature sen-
sor into the centre of the meat.
3. Put the plug of the core temperature
sensor into the socket on the side wall
of the oven.
Rare
Medium
Well done
If you set the Minute Minder when the
Duration
or End
ates, the symbol
Count Up Timer
Use the Count Up Timer to monitor how
long the oven operates.
Press
again and again until the display
shows time without clock symbols.
You cannot use the Count Up Timer
when the Duration
tion operates.
The display shows the symbol of the
core temperature sensor
default core temperature. When you
use the core temperature sensor for the
first time, the default core temperature
is 60 °C.
4. While
flashes, you can use the knob
for the temperature to change the de-
fault core temperature.
5. Press
to save the new core tempera-
ture setting, or wait 10 seconds for it to
be saved automatically. The new de-
fault core temperature is displayed dur-
ing the next use of the core tempera-
ture sensor.
6. Make sure that the core temperature
sensor stays in the meat and in the
socket during the cooking.
7. When the meat is at the set core tem-
perature, the symbol for the core tem-
perature sensor
temperature flash. An acoustic signal
sounds for two minutes. The appliance
deactivates automatically. Press a but-
ton to stop the signal.
8. Remove the plug of the core tempera-
ture sensor from the socket . Remove
the meat from the appliance.
The Duration and End do not operate
with the core temperature sensor.
function oper-
comes on in the display.
or End
func-
and the
and the default core
12
Печатать страницу