Avantco 178A19FHC Руководство пользователя - Страница 3

Просмотреть онлайн или скачать pdf Руководство пользователя для Холодильник Avantco 178A19FHC. Avantco 178A19FHC 9 страниц. Reach-in refrigerators & freezers
Также для Avantco 178A19FHC: Руководство пользователя (8 страниц)

Печатать страницу

Avantco 178A19FHC Руководство пользователя

1. Troubleshooting

Installation

This unit is intended for use in a temperature-controlled environment of less than 75°F and 60% relative

humidity. Malfunction due to improper conditions is not covered under warranty.

Before Installation

• If the shelf has a raised lip, the lip needs to be installed facing up towards the rear of the cabinet to promote

proper air flow. Failure to install the shelves properly is considered user error and is not covered by warranty.

• If the unit has recently been transported on its side, please let unit stand upright for a minimum of 24 hours

before plugging it in.

• Make sure that the unit has reached the desired temperature before loading the unit with products. This unit is

meant for keeping cold products cold, not chilling warm products.

• Make sure that there is proper ventilation around the unit in the area where it will operate.

• Make sure all accessories are installed (i.e., shelves, shelf clips, casters) before plugging in the unit.

• Do not attempt to remove or repair any component of the unit. Consult an authorized service technician for

servicing/repair.

• Do not hang on doors or stand inside the unit.

• Please read through the manual in its entirety.

Field Convertible Doors

The Avantco A-19R, A-19F, A-23R, and A-23F ship with a right-hinged door design. If you would like to convert the

reach-in to a left-hinged door design, you much purchase the bottom hinge separately (Avantco #178AKITFR) and

follow these instructions:

Tools Needed:

• Socket Set

• Pliers

• Adjustable Wrench

• Phillips Head Screwdriver

1. Remove the bottom vent by loosening the 4 screws that hold it in place. You do not need to fully remove the

screws as the vent will slide up and out.

2. Remove the top panel by unscrewing the 2 small screws. Once the screws are removed, the top panel will

hinge up.

3. Remove the small screws at the top and bottom door hinge where it attaches to the brackets.

Note: DO NOT lose the small washers.

4. Take off the top bracket by removing the 3 bolts.

5. The door should come off at this point.

Note: DO NOT lose the small round brass spacer on the bottom hinge.

6. Remove the 3 bolts holding the bottom bracket.

7. Replace the bottom hinge with the new left hand bottom bracket using 3 bolts.

8. You will need to adjust the top and bottom spring tensioners so the door will close properly.

9. Put the door on the bottom hinge on the left side. You will need to reuse the brass spacer from step 5.

Continued on next page.

User Manual

Reach-In Refrigerators & Freezers