KitchenAid 9741183 Руководство по установке - Страница 5
Просмотреть онлайн или скачать pdf Руководство по установке для Посудомоечная машина KitchenAid 9741183. KitchenAid 9741183 7 страниц. Undercounter dishwasher
Печатать страницу
n
'+,
Latch dishwasher door shut. Grasp
dishwasher door frame and slide dishwasher
off of shipping base or cardboard and into
cabinet opening.
Do Not push on
dishwasher door panels or console. Center
dishwasher in opening. Check that front
leveling legs are firmly against floor.
"% Align dishwasher door with cabinet
%.'-,,7
t
front -
not doors.
1 Place a level
against interior
flanqe in the
posi'iions shown
above. Level
dishwasher front to
back and side to
side by adjusting leveling legs.
newspm
Doors and
racks not
shown for
clarity.
"
2
" + Open dishwasher door and remove
bottom rack. Remove all shipping materials,
including
foam shipping pieces from upper
corners of door. Do Not remove the white
plastic plug buttons from the side of the
door or the plastic bumpers from the front
corners of the lower rack. Place a
newspaper or large sheet of paper over
bottom of dishwasher to protect pump area
when securing dishwasher to countertop.
Personal Injury/Product
Damage
Hazard
l
The dishwasher
must be secured to
the countertop
to keep it from
tilting
when the door is open.
l
If dishwasher
is to be installed
freestanding,
not in cabinet
enclosure,
dishwasher
must be
secured to the floor using Kit No.
4162841 available from your local
dealer.
l
Do Not drop screws in dishwasher
tub. If screws should fall into pump,
pump and motor damage may
occur.
Failure to follow
these instructions
may result in personal injury or
product
damage.
Doors and
racks not
shown for
clarity.
Numbers
correspond
to
steps.
3~ B The dishwasher must be secured to the
countertop
or floor to prevent tipping when
dishwasher door is opened.
Countertop
attachment:
' ' ' 1
Disconnect brackets located at top corners
of flange. Reattach brackets with bracket
end facing away from dishwasher. Using a
l/8" drill bit, drill 3/4" deep starter holes
through
bracket holes into underside of
countertop.
Do Not exceed 3/4" depth.
Attach brackets to underside of countertop
using two screws from parts bag. Make
sure screw heads do not interfere
with
door.
equally spaced
Open dishwasher door approximately
3"
and check for equal spacing between inner
door and tub sides. If space is unequal,
loosen screws fastening dishwasher to
countertop
and shift tub. Check that
dishwasher is level and reattach screws.
8
.
L Connect 3/8" NPT street elbow to a
90" compression elbow (3/8" NPT one
end). Connect street elbow to water valve.
Connect supply line to compression
elbow; or, if galvanized pipe is used,
connect supply line to a second 3/8" NPT
street elbow.
% &2 I Place screw-type clamp over
straight end of connector drain hose.
Attach drain hose to connector drain hose
with screw-type clamp. Check that drain
hose and connector drain hose are not
twisted or kinked and that the connection
is
secure.
Floor attachment:
leveling
leg
Attach dishwasher to floor using l/4" lag
bolts through
holes in each side of
dishwasher frame, being careful to keep
dishwasher level.
Panel D