HIKVISION TurboHD H0T Series Руководство пользователя - Страница 5

Просмотреть онлайн или скачать pdf Руководство пользователя для Камера безопасности HIKVISION TurboHD H0T Series. HIKVISION TurboHD H0T Series 13 страниц. Turbo hd bullet & dome camera
Также для HIKVISION TurboHD H0T Series: Руководство пользователя (17 страниц), Руководство пользователя (16 страниц), Руководство пользователя (17 страниц), Руководство пользователя (18 страниц), Руководство пользователя (15 страниц), Руководство пользователя (15 страниц), Руководство пользователя (17 страниц)

Печатать страницу
HIKVISION TurboHD H0T Series Руководство пользователя

2 Installation

Before you start
Make sure that the device in the package is in good
condition and all the assembly parts are included.
Make sure that all the related equipment is power-off
during the installation.
Check the specification of the products for the
installation environment.
Check whether the power supply is matched with
your power output to avoid the damage.
Make sure the wall is strong enough to withstand
three times the weight of the camera, and the
mount.
If the wall is cement, insert expansion bolts before
installing the camera. If the wall is wooden, use
self-tapping screws to secure the camera.
If the product does not function properly, contact
your dealer or the nearest service center. Do NOT
disassemble the camera for repair or maintenance by
yourself.
2.1 Installation of the Camera
2.1.1 Ceiling/Wall Mounting without Junction Box
Before you start:
The installation of ceiling mounting and wall mounting
are similar. Following takes ceiling mounting as an
example.
Steps:
1. Drill the screw holes and the cable hole (optional)
on the ceiling.
2. Route the cables through the cable hole, or the side
opening.
3. Attach the bracket to the ceiling, and secure the
camera with supplied screws. For cement ceiling,
you need to install the expansion bolts at first.
Figure 2-1 Attach the Camera to the Ceiling
Note:
The supplied screw package contains self-tapping
screws, and expansion bolts.
4. Connect the corresponding power cord, and video
cable.
5. Power on the camera to check whether the image
on the monitor is gotten from the optimum angle. If
not, loosen the screws and the trim ring to adjust
the position.
Rotation Position
[0° to 360°]
1). Loosen the T adjusting screw to adjust the tilt
position [0° to 180°].
Figure 2-2 3-Axis Adjustment
Pan Position
[0° to 360°]
Trim Ring
Tilt Position [0° to 180°]
T
R