KitchenAid KDFX 6050 Лист продукта - Страница 4
Просмотреть онлайн или скачать pdf Лист продукта для Посудомоечная машина KitchenAid KDFX 6050. KitchenAid KDFX 6050 16 страниц.
Печатать страницу
Brief instructions/ Overview
Before using the dishwasher, read the
installation and maintenance instructions
carefully.
Programme selection button
Press the button (repeatedly) until the desired
programme indicator light comes on up (see table
1.1). At the end of the wash cycle, the last
programme selected is saved.
Half load/ multi-zone button
Only load the upper or lower rack.
Factory setting - dishes in upper and lower rack
washed (both indicator lights on).
Press once = Dishes in lower rack washed
(indicator light on)
Press twice = Dishes in upper rack washed
(indicator light on)
At the end of the programme, the most recently
selected setting is saved.
If the top rack is not being washed, the "Wash
bottom rack" indicator lamp should be on.
Dynamic Clean
This function is selected by pressing and releasing
the button (the indicator lamp will light up).
Higher pressure with an additional jet for better
cleaning results and greater
bottom rack load flexibility.
At the end of the programme, the most recently
selected setting is saved.
Detergent setting upon initial use
and when using a different type of detergent
Indicator light off = Powder/gel detergent (factory
setting). If using combined detergents, press and
hold the button for 3 seconds. The indicator light
comes on = salt and rinse aid indicators go out.
From water hardness level 5, the salt indicator
stays on.
At the end of the programme, the most recently
selected setting is saved.
Time and malfunction display
In normal operation it indicates the remaining time
(h:mm), whereas with "Delayed start" selected it
indicates the time remaining until the programme
starts (e. g. h 01). When using
a sensor programme, a dotted line indicates that
the calibration process is underway (lasting up to
20 minutes).
If "F.. / E.." is displayed please read pages 14 and 15
"What to do if....".
Delayed start button
Push the button (repeatedly) to delay the start of
the programme. Can be set to 1-24 hours. This
delayed start is set in hourly steps
and after "h 24" starts again at "h 00". Then press
the Start button. The dishwasher will start at the
set time.
Start/Resume button
The indicator light comes on during operation,
flashes when the programme is interrupted before
completion and switches off at the end of the
programme.
Stop/Off button
Press the button to switch the dishwasher off or to
interrupt the selected programme. If the Stop/Off
indicator light flashes repeatedly, this indicates a
fault. Please see pages 14 and 15 "What to do if...".
Salt level indicator and rinse aid level
indicator
These light up at the end of the programme if the
rinse aid or salt needs topping up. Add just before
starting a wash cycle.
Running programme indicator
An LED light projected on the floor indicates that
the dishwasher is working.
4