Decora Y600 Series Руководство - Страница 8

Просмотреть онлайн или скачать pdf Руководство для Беговая дорожка Decora Y600 Series. Decora Y600 Series 13 страниц. Self-powered treadmill

moving and seek assistance as needed.

Tightening and guiding of walking belt

After placing the treadmill in the use position, you must check the

tightness and center alignment of the walking belt. After the first two

hours of use, it may be necessary to adjust the walking belt. Temperature,

humidity, and use may cause the walking belt to stretch to varying

degrees. If the walking belt starts sliding while the user is on the walking

belt, be sure to follow the instructions below.

1. Locate the two hex head bolts located behind the bearing housing on

the rear of the treadmill. The bolts are located at the rear of the two

bearing blocks on the rear of the treadmill. These bolts can be adjusted

for the rear running roller. Do not make adjustments until the treadmill is

turned on. This prevents one side from being too tight.

2. The walking belt should be located between the two sides of the rack,

keeping equal distance from both sides. Do not use the treadmill if the

walking belt touches one side. Turn the bolts on both sides

counterclockwise about one full turn. Push the walking belt between the

sides and manually place the walking belt in the center until the walking

belt is parallel to the side rails. Tighten the bolts the same amount as

when the user loosens, is about one full turn. Check the running belt for

damage.

3. Walk on the treadmill at approximately 4.8 kilometers per hour (3