Cequent Towing Products Signature Series Руководство по эксплуатации - Страница 3

Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Автомобильные аксессуары Cequent Towing Products Signature Series. Cequent Towing Products Signature Series 9 страниц. 24k 5th wheel hitch
Также для Cequent Towing Products Signature Series: Руководство по установке (11 страниц)

Печатать страницу

HITCHING PROCEDURE:

IMPORTANT:

YOU ARE RESPONSIBLE FOR SAFE HITCHING AND UNHITCHING OPERATIONS. DO NOT RELY ON

OTHERS TO PERFORM THESE DUTIES. YOU MUST PERSONALLY MAKE SURE THE FOLLOWING

STEPS ARE PERFORMED IN THE FOLLOWING ORDER!

FAILURE TO FOLLOW THESE INSTRUCTIONS MAY RESULT IN DEATH OR SERIOUS INJURY.

1. Place blocks (sometimes called "chocks") firmly against front and rear of each trailer wheel to prevent any possible

forward or rearward motion. DO NOT REMOVE BLOCKS UNTIL EACH OF THE FOLLOWING STEPS AND THE

PULL TEST HAVE BEEN COMPLETED. Lower tailgate if necessary. Clearance of the lowered tailgate to the trailer needs

to be monitored during hookups as some manufacturer combinations of truck and trailer have little or no clearance.

2. Using trailer jacks, adjust trailer height following the directions in the trailer manual so that bottom of trailer pin box ("A" in

Figure 2) is ½ to 1 inch below skid plate (See "B" in Figure 2). During the hitching maneuver, the bottom of the trailer pin

box should come in contact with skid plate ramp ("C" in Figure 2).

Hitch Skid Plate (B)

Figure 2

CORRECT

Failure to follow this instruction may result in king pin being too high and coming to rest on top of closed jaws or

not completely inside jaw. (See Fig. 6/7). This could result in trailer separating from hitch. Trailer separation may

result in death or serious injury if anyone is under the trailer or between truck and trailer when separation occurs.

3. Remove bail pin from bail pin hole(see Figure 4). Then pull handle out and rearward to hold open.

NOTE:

Pull handle out

and latch to the

rear to open

hitch jaw

4. With handle in the open position (See Figure 4), back truck slowly into trailer. As king pin completely enters

head, jaw will spring closed around king pin and handle will return to the closed position. (See Figure 5)

5. Use only the method described above for hitching.

30059OP - 15MAR05D

FOR KITS 30059, 40259 & 50259

Bottom of Pin Box (A)

1/2 To 1 Inch Below

Hitch Skid Plate (B)

Bottom of Pin Box (A)

Skid Plate Ramp (C)

Hitch jaw must be in the open position for king pin to enter the hitch.

Handle

PCN7735

WARNING:

Bail Pin Hole

Figure 4

Flag

Figure 5

Bottom of

Box Above

Hitch Skid

Figure 3

WRONG

Hitch Jaw

King pin

LITHO IN USA

Plate