Avantco 177AG24MG Установка, эксплуатация и обслуживание - Страница 3
Просмотреть онлайн или скачать pdf Установка, эксплуатация и обслуживание для Торговое пищевое оборудование Avantco 177AG24MG. Avantco 177AG24MG 17 страниц. Manual griddles, radiant charbroilers, hot plates
Печатать страницу
Operation of this equipment must be performed by qualified or authorized personnel who
have read and are familiar with the functions of the equipment.
MAINTENANCE
To perform maintenance and repairs of the appliance, please contact the factory, the factory
representative, or the nearest authorized local service company.
RATING PLATE
Information on this plate includes the model, serial number, BTU/hour input of the burners,
operating gas pressure in inches WC, and whether the appliance is orificed for natural or
propane gas. When communicating with factory about a unit or requesting special parts or
information, rating plate data is essential for proper identification.
AVANTCO COOKING APPLIANCES MUST BE CONNECTED ONLY
TO THE TYPE OF GAS IDENTIFIED ON THE RATING PLATE
CLEARANCES
The appliance area must be kept free and clear of all combustibles.
AVANTCO MODEL
177AG (24/36/48) MG - Manual Griddles
177AG (24/36/48) RC - Radiant Charbroilers
177AGR (212/424/636) - Hot Plates
AIR SUPPLY AND VENTILATION
The area in front of, around, and above the appliance must be kept clear to avoid any
obstruction of the flow of combustion and ventilation of air.
Adequate clearance must be maintained around the appliance for easy servicing.
Provisions should be made for any commercial, heavy duty cooking appliance to have its
exhaust combination waste products released to the outside of the building. The usual
practice is to place the appliance under an exhaust hood, which should be constructed in
accordance with local codes.
Strong exhaust fans in this hood or in the overall air conditioning system can produce a slight
vacuum in the room and/or cause air drafts, either of which can interfere with the pilot or
burner performance and could be difficult to diagnose. Air movement should be checked
during installation. Air openings or baffles may have to be provided in the room, if pilot or
burner outage problem persists.
GAS CONNECTION
The gas supply (service) line must be the same size or greater than the inlet line of the
appliance. Avantco appliances use a ¾" NPT inlet. Sealant on all pipe joints must be resistive
to LP gas.
MANUAL SHUT OFF VALVE
This installer-supplied valve must be in the gas service line ahead of the appliance regulator
in the gas stream and in position accessible in the event of an emergency.
OPERATING INSTRUCTIONS
Combustible
Rear
Sides
8"
10"
8"
10"
8"
10"
Non-Combustible
Rear
Sides
0"
0"
0"
0"
0"
0"
Page |
3