Green Stoves 10KW Руководство по установке и эксплуатации - Страница 7

Просмотреть онлайн или скачать pdf Руководство по установке и эксплуатации для Печи Green Stoves 10KW. Green Stoves 10KW 14 страниц. Freestanding boiler stoves
Также для Green Stoves 10KW: Руководство по установке и эксплуатации (17 страниц)

Печатать страницу

Green Stoves 10KW Руководство по установке и эксплуатации

Combustion air supply

In order for the stove to perform efficiently and safely there must be an adequate air supply into the room in

which the stove is installed to provide combustion air. The provision of air supply to the stove must be in

accordance with current Building Regulations Approved Document J. An opening window is not appropriate

for this purpose. If it was necessary to fit a draught stabilizer due to excessive chimney draught then attention

must be paid to the permanent combustion air requirements as this will be different as detailed in Approved

Document J.

Connection to chimney

All the stoves have a choice of either rear or top flue gas connector that allows connection to either a masonry

chimney or a prefabricated factory made insulated metal chimney in accordance with the instructions. It may be

necessary to fit an adaptor to increase the diameter of the flue to the required 150 mm section of the chimney or

liner.

Material Clearances

The stove can be recessed in a suitable sized fireplace but a permanent free air gap of at least 150mm must be

left around the sides and top and at least 50mm at the back of the stove to obtain maximum heat output and for

access to the rear of the stove.

All non-combustible walls closer than 400mm to the stove should be at least 75mm thick. In all instances the

back wall of the fireplace recess and the hearth should be made of non-combustible material. Allow an apron of

at least 300mm at the front of the stove and 150mm on either side. The hearth on which the stove is to be placed

should not be less than 125mm thick and should be in accordance with the current building regulations.

Care should be taken to level the stove using the adjusting screws in the feet.

The appliance shall be installed on a floor with adequate load-bearing capacity. If the existing construction does

not meet this prerequisite, suitable measures (e.g. load disturbing plate) should be taken to achieve it.

Safety Distances from Combustible Surfaces:

Green 8

Green 10

Green 20

Green 25

Green 30

Sides

Rear

200mm