IKEA LAGAN Руководство - Страница 11

Печатать страницу

ENGLISH

General information

Manufacturer is not responsible for any

injury to persons and pets or damage to

property caused by failure to comply

following requirements.

Caution! To proceed with the

installation refer to the assembly

instructions.

Warning! Installation process

must follow the laws, ordinances,

directives and standards

(electrical safety rules and

regulations, proper recycling in

accordance with the regulations,

etc.) in force in the country of use!

Warning! The appliance must be

earthed!

Warning! Risk of injury from

electrical current.

• The electrical mains terminal is live.

• Make electrical mains terminal free of

voltage.

• Loose and inappropriate plug and

socket connections can make the

terminal overheat.

• Have the clamping connections correctly

installed.

• Use strain relief clamp on cable.

• Follow the connection diagram (it is

located on the underneath surface of the

casting of the hob).

Important!

• You must observe the minimum distances

to other appliances and furniture

cabinets or other units according to

Assembly Instruction.

• If there is no oven beneath the hob insert

a dividing panel at a minimum distance

of 20 mm from the bottom of the hob.

• Do not use silicon sealant between the

appliance and the worktop. Avoid

installing the appliance next to doors

and under windows as hot cookware

may be knocked off the rings when doors

and windows are opened.

• Only an authorized service engineer can

install, connect or repair this appliance.

Use only original spare parts.

Electrical connection

• Before connecting, check that the

nominal voltage of the appliance stated

on the rating plate, corresponds to the

available supply voltage. Also, check the

power rating of the appliance and

ensure that the wire is suitably sized to

suit the appliance power rating (refer to

the "Technical information" chapter). The

rating plate is located on the lower

casing of the hob.

• The appliance is not provided with a

mains cable. Buy the right one from

specialized dealer. Single phase or two-

phase connection requires a mains cable

of minimum 90°C temperature stability.

Cable has been provided with end

sleeves. According to IEC regulations use

for one-phase connection: mains cable 3

x 4mm² and for two-phase connection:

mains cable 4 x 2.5mm². Please respect

in first priority specific national

regulations.

• The appliance works perfectly on AC

230 V, AC 220 V~ or AC 240 V~ 50 Hz

electrical network.

• You must have the means for

disconnection incorporated in the fixed

wiring. Have the appliance connected to

the mains using a device that allows the

appliance to be disconnected from the

mains at all poles with a contact opening

width of at least 3 mm, eg. automatic line

protecting cut-out, earth leakage trips or

fuse.

• You must have the connection and the

connecting links carried out as shown in

the connection diagram (it is located on

the underneath surface of the casing of

the hob). The earth lead is connected to

terminal marked with the symbol and