EN
PROGRAMS TABLE
Programs
Eco
1.
Intensive
2.
Normal
3.
Pre-Wash
4.
ECO program data is measured under laboratory conditions.
* The duration of the program shown on the display or in the booklet is an estimate calculated on standard conditions. The actual time
may vary depending on many factors such as temperature and pressure of the incoming water, room temperature, amount of deter-
gent, quantity and type of load,load balancing, additional selected options and sensor calibration. The sensor calibration can increase
program duration up to 20 min.
Standby consumption: Left-on mode consumption: 5 W - Off mode consumption: 0.5 W
PROGRAMS DESCRIPTION
1.
ECO - Normally soiled crockery. Standard program, the most efficient in terms of its combined energy and water consumption.
2.
INTENSIVE - Program recommended for heavily soiled crockery, especially suitable for pans and saucepans (not to be used for delicate
items).
3.
NORMAL - Normally soiled crockery. Everyday cycle, that ensures optimal cleaning performance in shorter time.
4.
PRE-WASH - Crockery to be washed later. No detergent to be used with this program.
Notes: To reduce consumption even further, only run the dishwasher when it is full.
DAILY USE
1. CHECK WATER CONNECTION
Check that the dishwasher is connected to the water supply
and that the top is open.
2. SWITCH ON THE DISHWASHER
Open the door and press the ON/OFF button.
3. LOAD THE RACKS
(see LOADING THE RACKS)
4. FILLING THE DETERGENT DISPENSER
(see PROGRAMS TABLE).
5. CHOOSE THE PROGRAM AND CUSTOMISE THE CYCLE
Select the most appropriate program in accordance with the
type of crockery and its soiling level (see PROGRAMS DE-
SCRIPTION) by pressing the P button.
Select the desired options (see OPTIONS AND FUNCTIONS).
6. START
Start the wash cycle by closing the door. When the program
starts you hear a beep.
7. END OF WASH CYCLE
The end of the wash cycle is indicated by beeps and by the
flashing of the indicator light of the selected program. Open
the door and switch off the appliance by pressing the ON/OFF
button. Wait for a few minutes before removing the crockery - to
avoid burns. Unload the racks, beginning with the lower one.
Detergent
Drying
dispenser
phase
B
TUB
-
-
-
-
-
The machine will switch off automatically during certain
extended periods of inactivity, in order to minimise electri-
city consumption. If the crockery is only lightly soiled or
if it has been rinsed with water before being placed in the
dishwasher, reduce the amount of detergent used accordingly.
MODIFYING A RUNNING PROGRAM
If a wrong program was selected, it is possible to change it,
provided that it has only just begun: open the door (be ware of
HOT steam!), press and hold the ON/OFF button, the machine
will switch off.
Switch the machine back on using the ON/OFF button and select
the new wash cycle and any desired options; start the cycle by
closing the door.
ADDING EXTRA CROCKERY
Without switching off the machine, open the door (be ware of
HOT steam!) and place the crockery inside the dishwasher.
Close the door and the cycle will begin from the point at which it
was interrupted.
ACCIDENTAL INTERRUPTIONS
If the door is opened during the wash cycle, or if there is a power
cut, the cycle stops. It starts again from the point at which it was
interrupted once the door has been closed or the electricity
supply is restored.
10
Duration of
Water
wash cycle
consumption
(h:min)
(l/cycle)
*
3:10
11.0
2:30
16.5
2:00
16.0
0:10
4.0
Energy
cosumption
(kWh/cycle)
1.04
1.65
1.35
0.01
Печатать страницу