ALIBI ALI-BC1080P Руководство по быстрой установке
Просмотреть онлайн или скачать pdf Руководство по быстрой установке для Камера безопасности ALIBI ALI-BC1080P. ALIBI ALI-BC1080P 2 страницы. Hd-tvi outdoor infrared bullet camera
Печатать страницуALI-BC1720P, ALI-BC1080P HD-TVI
Outdoor Infrared Bullet Camera
Quick Installation Guide
The ALIBI ALI-BC1080P and ALI-BC1720P cameras feature a 1/3" CMOS image sensor that delivers high-
definition video resolution over RG59 coax or any standard analog CCTV cabling up to 1600'. These HD
video camera is ideal for security applications that require a high level of detail, such as facial recognition or
license plate identification.
Features
CMOS image sensor
•
HD-TVI technology produces 1280x720 (720p, ALI-BC1720P) or 1920x1080 (1080p, ALI-BC1080P)
•
HD video for sharp, detailed images
3.6 mm wide angle (77°) lens captures images over large areas
•
HD-TVI technology transmits zero latency HD video resolution over coax cabling
•
Built-in IR with 24 LEDs enables the camera to see up to 65' in the dark
•
Smart IR technology reduces over-exposure of the IR LEDs at the center of the image
•
True day/night (ICR) captures sharp, clear images in low light and at night
•
-40 °F ~ 140 °F (ALI-BC1720P) extreme temperature operating range
•
IP66 weather-rated housing
•
Adjustable
mounting
bracket
Camera body
IR LED Array
ALI-BC1720P and ALI-BC1080P cameras
ALI-BC1720P Camera drop cable connectors
ALI-BC1080P camera drop cable connectors
www.observint.com
1
Mounting base
Lens
HD-TVI video BNC
Connector
Power
Connector
HD-TVI video BNC
Connector
CVBS video BNC
Connector
Power
Connector
RS-485 leads
What's in the box
Camera assembly
•
Mounting hardware
•
This instruction guide
•
Drill template
•
Tools you need
To install the camera, you will need:
12 Vdc power source. See Specifications for wattage requirement.
•
Tools and additional fasteners (may be required) for mounting the camera
•
Phillips screwdriver
•
Video and power extension cable
•
CCTV video setup monitor (optional)
•
Installation
Before installation:
Make sure that the device is in good condition and all the assembly parts are included.
•
Check the specification of the products for the installation environment.
•
Make sure that the wall or the ceiling is strong enough to withstand 3 times the weight of the camera.
•
To avoid fire or shock hazard, use only UL listed power supplies. Verify that the power supply will
•
provide the rated voltage and wattage for the camera. See the Specifications section.
During installation:
Camera Lens: Handle the camera carefully to prevent scratching or soiling the lens. If the lens or IR
•
array shield becomes soiled, clean it only with approved products. See the
Monitor impedance: Set the monitor impedance switch to 75 Ω.
•
Power supply: Camera drop cable: The camera drop cable includes two connectors:
•
Video BNC connector: For transmission of the video signal across a coax (75 Ω) extension cable.
—
Power connector: When applying Vdc power, observe the power polarity. See the picture below
—
for the connector polarity configuration.
Mounting the camera
These cameras can be mounted on a wall or ceiling that has sufficient strength to support it. The video/
power drop cable from the camera can be routed either through mounting surface or through a cable guide
on the edge of the mounting base.
Typical ceiling mounting
If mounting the camera on a wall, ensure that the label on the mounting base, "
NOTE
If mounting the camera on a ceiling, orient the mounting base so that the cable guide is pointing
away from any source of water, dust, and other contaminates.
1.
Using the drill template provided, mark the location of the screws that anchor the mounting base
to the mounting surface. See the note above. If you are routing the drop cable through mounting
surface, also mark the position of the hole for the drop cable.
2.
Drill holes for the screws that anchor the base to the mounting surface. The mounting hardware
provided is appropriate for most surfaces. However, depending on the surface materials, more
appropriate fasteners may be required.
section.
Cleaning
," is down.
Bottom
ALI-BC1080P-1720P_CQ
10/21/14