GAPOSA SileoXS XSDC3EX226BI Краткое руководство по эксплуатации - Страница 6

Просмотреть онлайн или скачать pdf Краткое руководство по эксплуатации для Оконные жалюзи GAPOSA SileoXS XSDC3EX226BI. GAPOSA SileoXS XSDC3EX226BI 8 страниц. Ultra quiet motorization

Печатать страницу

6. ADDING TRANSMITTERS

Press and hold the PROG-

TX button on the back of

transmitter ALREADY PAIRED

until the motor starts moving

7. CHECKING / CHANGING DIRECTION

Press UP or DOWN the motor should go UP or DOWN, otherwise to change the motor direction:

Press and hold the PROG-TX button on the

back of transmitter until the motor starts

moving

8. LIMIT SWITCH SETUP

Run the motor to an intermediate position

inbetween the two desired limits. The

motor needs to move in the direction

of the limit in order for the limit to be

properly set.

Press and hold the PROG-FC

button on the back of transmitter

until the motor makes a brief jog.

Note: during "programming

mode" the operations are in

"deadman control" (The UP and

DOWN buttons must be held

down inorder to move the motor)

Note: Accurate limit setting can be performed when UPWARD or DOWNWARD by pressing the PROG-FC button

a second time: the motor then moves slowly in steps towards to the desired limit. Always press STOP button

to set the limit position

Check the motor rotation

then release the PROG-TX

button (the motor stops)

Press STOP: The motor makes a brief jog. Direction of the

motor has been reversed.

IMPORTANT: change direction must be performed before

starting limit setting otherwise limits must be reset

ALWAYS SET THE UP LIMIT FIRST.

Press and hold the

UP button and run

the motor to the

desired UP limit

position

Press and hold the

DOWN button and

run the motor to the

desired DOWN limit

position.

Within 5 seconds, press the

corresponding button (UP if the

motor turns upwards or DOWN if

the motor turns downwards) on

the new transmitter that needs to

be programmed

Press STOP to set the

UP limit position. The

motor makes a brief jog

to confirm

Press STOP to set the

UP limit position. The

motor makes a brief

jog to confirm.