Makita 1911B Руководство по эксплуатации - Страница 4
Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Электроинструмент Makita 1911B. Makita 1911B 16 страниц. Power planer
Также для Makita 1911B: Руководство по эксплуатации (12 страниц), Руководство по эксплуатации (13 страниц), Руководство по эксплуатации (18 страниц), Руководство по эксплуатации (12 страниц)
Печатать страницу
SERVICE
23. Tool service must be performed only by
qualified repair personnel. Service or main-
tenance performed by unqualified personnel
could result in a risk of injury.
USE PROPER EXTENSION CORD: Make sure your extension cord is in good condition.
When using an extension cord, be sure to use one heavy enough to carry the current your
product will draw. An undersized cord will cause a drop in line voltage resulting in loss of
power and overheating. Table 1 shows the correct size to use depending on cord length and
nameplate ampere rating. If in doubt, use the next heavier gage. The smaller the gage num-
ber, the heavier the cord.
Ampere Rating
More Than
0
6
10
12
SPECIFIC SAFETY RULES
DO NOT let comfort or familiarity with product (gained from
repeated use) replace strict adherence to planer safety rules. If
you use this tool unsafely or incorrectly, you can suffer serious
personal injury.
1. Rags, cloth, cord, string and the like
should never be left around the work area.
2. Avoid cutting nails. Inspect for and
remove all nails from the workpiece
before operation.
3. Use only sharp blades. Handle the blades
very carefully.
4. Be sure the blade installation bolts are
securely tightened before operation.
5. Hold the tool firmly with both hands.
4
Table 1: Minimum gage for cord
Not More Than
6
10
12
16
24. When servicing a tool, use only identical
replacement parts. Follow instructions in
the Maintenance section of this manual.
Use of unauthorized parts or failure to follow
Maintenance instructions may create a risk of
electric shock or injury.
Volts
Total length of cord in feet
120 V
25 ft.
18
18
16
14
6. Keep hands away from rotating parts.
7. Before using the tool on an actual work-
piece, let it run for a while. Watch for
vibration or wobbling that could indicate
poor installation or a poorly balanced
blade.
8. Make sure the blade is not contacting the
workpiece before the switch is turned on.
9. Wait until the blade attains full speed
before cutting.
50 ft.
100 ft.
AWG
16
16
16
14
16
14
12
Not Recommended
150 ft.
14
12
12
USB042-2