Makita 3703 Руководство по эксплуатации - Страница 6

Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Электроинструмент Makita 3703. Makita 3703 12 страниц. Trimmer
Также для Makita 3703: Руководство по эксплуатации (20 страниц)

Печатать страницу
Makita 3703 Руководство по эксплуатации
side in the feed direction. This will help to keep it
flush with the side of the workpiece.
2
1
001985
CAUTION:
Since excessive cutting may cause overload of the
•
motor or difficulty in controlling the tool, the depth of
cut should not be more than 3 mm at a pass when
cutting grooves. When you wish to cut grooves
more than 3 mm deep, make several passes with
progressively deeper bit settings.
Templet guide
004555
The templet guide provides a sleeve through which the
bit passes, allowing use of the trimmer with templet
patterns.
Remove the chip deflector.
1
2
3
004556
Loosen the screws and remove the base protector. Place
the templet guide on the base and replace the base
protector. Then secure the base protector by tightening
the screws.
Secure the templet to the workpiece. Place the tool on
the templet and move the tool with the templet guide
sliding along the side of the templet.
1. Feed direction
3
2. Bit revolving
direction
3. Workpiece
4. Straight guide
4
1. Screwdriver
2. Base protector
3. Screws
3
1
2
4
5
6
10 mm (3/8")
004557
NOTE:
The workpiece will be cut a slightly different size
•
from the templet. Allow for the distance (X)
between the router bit and the outside of the
templet guide. The distance (X) can be calculated
by using the following equation:
Distance (X) = (outside diameter of the templet guide -
router bit diameter) / 2
Straight guide (Accessory)
004558
The straight guide is effectively used for straight cuts
when chamfering or grooving.
Attach the guide plate to the straight guide with the bolt,
the wave washer, the flat washer and the wing nut.
1
2
3
4
001990
Remove the chip deflector.
1
2
3
004559
6
1. Base
3
2. Straight bit
3. Templet guide
4. Templet
5. Workpiece
6. Distance (X)
1. Bolt
2. Guide plate
3. Straight guide
4. Wing bolt
1. Clamp screw (A)
2. Straight guide
3. Wing nut
4. Base
4