CORNING OptiTect Краткое руководство по эксплуатации - Страница 12
Просмотреть онлайн или скачать pdf Краткое руководство по эксплуатации для Лабораторное оборудование CORNING OptiTect. CORNING OptiTect 18 страниц.
Печатать страницу9 .1
Install Braided Tubing
Step 1:
Cut the braided tubing 4 feet shorter than the exposed ribbon length. Refer to
Figure 11 and Table 1 to verify the number of braided tubes required, the lengths,
and routing configurations for your cabinet.
Step 2:
Attach the plastic rod supplied in
the braided tubing kit to the end of
the fiber(s) with the electrical tape
(Figure 12).
Step 3:
Push the braided tubing over the rod
(Figure 13).
Step 4:
Slide tubing toward the cable sheath
(Figure 14).
•
•
•
•
Step 5:
Push the tubing up to the edge of the cable sheath
(Figure 15).
STANDARD RECOMMENDED PROCEDURE 003-873 | ISSUE 2 | APRIl 2016 | PAGE 12 OF 18
Hold the tube as shown.
Compress the tubing.
Move the compressed length up the rod
toward the cable sheath.
Repeat the procedure until the rod appears
out the end of the tubing.
KPA-0002
Figure 12 — Attach Plastic Rod
KPA-0003
Figure 13 — Install Braided Tubing
3
1.3 cm
(0.5 in)
8 cm (3 in)
1
2
KPA-0004
Figure 14 — Slide Tubing
KPA-0005
Figure 15 — Push Tubing