Avantco Equipment MX60 Руководство пользователя - Страница 16

Просмотреть онлайн или скачать pdf Руководство пользователя для Торговое пищевое оборудование Avantco Equipment MX60. Avantco Equipment MX60 17 страниц. Gear driven 60 qt. commercial mixer

Печатать страницу

User Manual

Qty

Cleaning

The machine must be put in the dry and flat ground, and make sure the

machine steadily.

WARNING: DISCONNECT THE MACHINE FROM THE POWER SOURCE BEFORE CLEANING

We can use four screws to fix the bracket, so the mixer will not shake or

All new mixer bowls and accessories including whips, beaters, and dough hooks should be properly washed before use.

Wash with hot water and a mild soap solution and then rinse off with either a mild vinegar or soda solution and then rinse

slope.

again with clean water. It is highly recommended this cleaning procedure is followed for bowls and accessories prior to

whipping egg whites or whole eggs. The mixer should be cleaned daily with a clean damp cloth.

Check the power voltage is suitable for voltage of this mixer or not befo-

If the unit has not been used for some time, it is recommended that the procedure above is followed before mixer use.

It is important that the rear bowl lift guides are greased every three months to prevent corrosion.

re using, the ground wire is firm whether or not.

Troubleshooting

When the motor of this machine is equipped with 380V, you can ask the

SB4

Trouble

professional electricians to fix the electrical source. If you find that run-

The axles can't work when

ning direction is not right, you can change the two wires, besides the gr-

operating the machine

The mixing bowl is out of position

ound wire.

Leaks oil

Difficult to move the bowl up and down

Warning: users must install the shell ground wire.

The motor is overheated

and speed is down

Noise and overheating

Mixer touches bowl

The machine must be put in the dry and flat ground, and make su

machine steadily.

We can use four screws to fix the bracket, so the mixer will not sh

slope.

Check the power voltage is suitable for voltage of this mixer or no

re using, the ground wire is firm whether or not.

When the motor of this machine is equipped with 380V, you can a

professional electricians to fix the electrical source. If you find th

Possible Causes

ning direction is not right, you can change the two wires, besides

Poor contact of the electrical

equipment

ound wire.

Moving direction is not correct

Sealing washer is damaged

Warning: users must install the shell ground wi

Slideway is rusted

The voltage is not enough, or

incorrect speed

Poor lubrication

The mixing device or bowl de-

formed

Solution

Check the Plug

Change

Clean the slideway and lubricate

Check the voltage or use

lower speed

Add or change lubrication

Repair or change the bowl

or mixing device