GarageAce R5 Руководство по установке - Страница 7
Просмотреть онлайн или скачать pdf Руководство по установке для Открыватель двери гаража GarageAce R5. GarageAce R5 20 страниц. Roller garage door opener
Печатать страницу5. Testing the Door
Complete the following test to ensure your door is well
balanced, and not sticking or binding:
•
Disable all locks and remove any ropes connected to the
garage door.
•
Lift the door to about halfway and then release it. The
door should remain spring balanced.
•
Raise and lower the door to determine if there are any
sticking or binding points (20 kgf is the absolute
maximum allowable to raise or lower the door in any
position).
•
If your door does not hold in place or the door binds or
sticks, call a qualified door technician before installing
the opener.
6. Installing the Stop Collar
•
Install the stop collar on the opposite end to where the
opener is to be installed.
•
Fit the stop collar hard against the boss of the door
drum. Ensure the U-bolt holding the door shaft to the
door bracket is tightly secured
7. Installing the Weight Bar
(optional accessory)
•
Place the weight in the centre of the door (as shown).
•
Use a pencil to mark the two hole positions.
•
If the door curtain does not have a handle you will need
to drill two 6.5 mm holes through the two marked
positions, then place the weight bar on the inside of the
door.
•
Use the bolts and nuts (provided) to fasten the weight
bar in place.
NOTE: If the door has a lifting handle, remove the
handle, nuts and bolts. Place weight bar over the handle
holes, insert extended bolts through the weight bar and
fasten handle back in place.
SAFETY CHECK!
Is the stop collar installed?
YES: proceed to the next step
NO: install the stop collar before proceeding
7