GarageAce S6 Руководство пользователя - Страница 12
Просмотреть онлайн или скачать pdf Руководство пользователя для Открыватель двери гаража GarageAce S6. GarageAce S6 20 страниц. Sectional/tilt garage door opener
Печатать страницуonce. The dot will go off. Press the same
remote button again (within 20 seconds)
and the dot will flash fast 8 times, then
return to standby mode.
The button is now set up to control that
particular door. You can set up other
buttons on the same remote to control
other doors using the same procedure.
The system has the capacity to store up to
20 remotes.
If the LED display flashes "F" and returns
to standby mode (after you have pressed
the Code button), this indicates that the
memory storage is full (20 remotes).
You will need to delete all remotes and
start over. To delete all remotes, press and
hold the "CODE" button for more than 8
seconds until the LED flashes "C". All the
remotes are now deleted.
Setting the Travel Limits
This operation will set the open position
of the door and also the closed position.
This always needs to be done for new
installations.
Open Position - Press and hold the
"SET" button for 3 seconds until the LED
flashes "1". Press "SET" button again for
1 second. "1" should now display steadily
(not flashing). Adjust the upper limit by
pressing "UP" button until the door is
positioned where you consider it to be fully
opened. You can fine-tune the position
using the "UP" or "DOWN" buttons. (The
LED flashes "n" or "u" during opening or
closing.) Then press "SET" button to save
the position. The display will change to "2"
automatically.
Closed Position - Now adjust the down
limit by pressing "DOWN" button until
the door is positioned where you consider
it to be fully closed. You can fine-tune
the position using the "UP" or "DOWN"
buttons. (The LED flashes "n" or "u" during
opening or closing.) Then press "SET"
button to save the position.
12
TM
S6 Instruction Manual
SET
UP
M
CODE
DOWN
SET
UP
M
CODE
DOWN