CORNING SCRN-510 Руководство по установке оборудования - Страница 11
Просмотреть онлайн или скачать pdf Руководство по установке оборудования для Сетевое оборудование CORNING SCRN-510. CORNING SCRN-510 17 страниц. Small cell radio node
Печатать страницу7.1
Flush Mounting the SCRN-510
As shown in
Figure
3, the SCRN-510 comes with the ceiling-mount bracket attached. This bracket is held to the
radio node mounting side with four shoulder screws and a captive securing screw, and is non-tilting. The
shoulder screws should not need to be adjusted but if they do, loosen them slightly to be able to slide the ceil-
ing-mount bracket on and off of the radio node when the captive securing screw has been loosened.
shows the captive securing screw and four security screw locations.
NOTE: The security screws should not need to be adjusted but if they do, loosen them slightly to be able to slide
the ceiling-mount bracket on and off.
Step 1 Loosen the captive securing screw on the ceiling-mount bracket.
Step 2 Slide the ceiling-mount bracket toward the captive securing screw to remove it from the SCRN-
510 base.
NOTE: The shoulder screws should not need to be adjusted but if they do, loosen them slightly to be able to
slide the ceiling-mount bracket on and off.
Step 3 Secure the ceiling tethering system. Make sure that it can support the weight of the SCRN-510
and the ceiling-mount bracket.
NOTE: Corning recommends that you use a customer-supplied projector mount when hanging the SCRN-510
from a dropped T-bar ceiling.
Step 4 Secure the ceiling-mount bracket to ceiling tethering system.
Step 5 Slide the radio node back onto the bracket and gently tighten the securing screw.
Figure 7
shows a typical SCRN-510 mounted to a ceiling tethering system.
Corning Restricted and Confidential Proprietary - Controlled content
SCRN-510 Hardware Installation Guide | DOC-SCRN-510-HIG_i4 | 16 October, 2020 | Page 11
Figure 6
Ceiling-Mount Bracket Screw Locations
Figure 6