Makita 4341FCT Техническая информация об аппаратном обеспечении - Страница 7
Просмотреть онлайн или скачать pdf Техническая информация об аппаратном обеспечении для Электроинструмент Makita 4341FCT. Makita 4341FCT 14 страниц. Jig saw
Также для Makita 4341FCT: Технические характеристики (2 страниц), Разбивка на части (3 страниц), Руководство по эксплуатации (13 страниц)
Печатать страницу
R
epair
< 7 > Disassembling blade holder
1. Disassemble rod with referring to "< 5 > Disassembling gear housing cover section" at page 4.
2. Disassemble dust cover, and then disassemble retaining ring R-18. as illustrated in Fig. 12.
So, blade holder and torsion spring 15 can be separated from rod as illustrated in Fig. 12A.
Dust cover
Retaining
ring R-18
Rod
Blade holder
Fig. 12
< 8 > Assembling blade holder
1. Apply MAKITA grease FA No.2 to push pin and set it in the hole of rod. And assemble torsion spring 15 to rod by
inserting its tail shown in Fig. 13 into the hole of rod.
2. Set blade holder to rod as illustrated in Fig. 14. And bring the tail of torsion spring 15 to the space A of blade
holder as illustrated in Fig. 15.
Rod
Push pin
Torsion spring 15
Insert this tail into
the hole of rod.
3. Push rod into blade holder, and assemble retaining ring R-18 to the groove in blade holder as illustrated in Fig. 16.
4. Assemble dust cover as illustrated in Fig.17.
Retaining ring R-18
Be careful, not to lose push pin,
when disassembling.
Aligning the mark
of blade holder and
Fig. 13
push pin, set blade holder
to rod.
Fig. 16
Blade holder
Fig. 12A
Bring this tail to the
space A of blade
holder by turning
clockwise.
Blade holder
Fig. 14
Dust cover
Fig.17
Torsion spring 15
Fig. 15
Press dust cover to assemble
firmly to blade holder.
P 7 / 14
Space A