Makita 4350FCT Руководство по эксплуатации - Страница 8
Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Электроинструмент Makita 4350FCT. Makita 4350FCT 13 страниц. Jig saw
Также для Makita 4350FCT: Технические характеристики (2 страниц), Разбивка на части (3 страниц), Руководство по эксплуатации (13 страниц), Техническая информация (14 страниц), Руководство по эксплуатации (13 страниц)
Печатать страницу
1
4
5
008014
Front flush cuts
1
2
008015
Loosen the bolt on the back of the base with the hex
wrench and slide the base all the way back. Then
tighten the bolt to secure the base.
Cutouts
Cutouts can be made with either of two methods A or B.
A) Boring a starting hole:
008016
For internal cutouts without a lead-in cut from an
edge, pre-drill a starting hole 12 mm or more in
diameter. Insert the blade into this hole to start
your cut.
B) Plunge cutting:
008017
You need not bore a starting hole or make a lead-
in cut if you carefully do as follows.
1. Graduation
2
3
2. Bevel slot
3. Base
4. Gear housing
5. V-notch
6. Bolt
6
1. Base
3
2. Bolt
3. Hex wrench
1. Starting hole
1
(1)
Tilt the tool up on the front edge of the base
with the blade point positioned just above the
workpiece surface.
(2)
Apply pressure to the tool so that the front
edge of the base will not move when you
switch on the tool and gently lower the back
end of the tool slowly.
(3)
As the blade pierces the workpiece, slowly
lower the base of the tool down onto the
workpiece surface.
(4)
Complete the cut in the normal manner.
Finishing edges
008018
To trim edges or make dimensional adjustments, run the
blade lightly along the cut edges.
Metal cutting
Always use a suitable coolant (cutting oil) when cutting
metal. Failure to do so will cause significant blade wear.
The underside of the workpiece can be greased instead
of using a coolant.
Dust extraction
001921
001922
The dust nozzle (accessory) is recommended to
perform clean cutting operations.
To attach the dust nozzle on the tool, insert the hook of
dust nozzle into the hole in the base.
8
1. Dust nozzle
1
2. Base
2