CORNING PCH-02U Краткое руководство по эксплуатации - Страница 4

Просмотреть онлайн или скачать pdf Краткое руководство по эксплуатации для Кабели и разъемы CORNING PCH-02U. CORNING PCH-02U 10 страниц.

Installation

4.1

Removing the cover is optional but is recommended to ease installation.

Step 1:

Open front and rear doors.

Step 2:

Locate the plunger fasteners at the front of the unit under the housing cover and pull

out to release the plungers (Figure 3).

Step 3:

Lift stop latches and slide the cover of the unit toward the front until it is clear of the

base. Set the cover aside.

KPA-0149

4.2

Attach the unit to the equipment rack using the four screws provided. Two screws are required

per side.

4.3

Step 1:

Determine location for cable entry into housing.

Step 2:

Slide drawer back completely. The drawer must be in this position to prevent fiber

damage during drawer actuation.

Step 3:

Prepare the appropriate cable entry grommet (Figure 4).

Step 4:

Install cable entry plate using the provided screw (Figure 5) at the location where the

cable will enter the housing.

Step 5:

Install the strain-relief bracket to the side of the housing (Figure 5) at the location

where the cable will enter the housing.

STANDARD RECOMMENDED PROCEDURE 003-722 | ISSUE 4 | OCTObER 2015 | PAGE 4 OF 10

Plunger fasteners

Use a pair of needle-nose pliers or sharp

pencil to pierce the grommet. Do not use a

knife or cutters. The grommets must fit

tightly to prevent the intrusion of

foreign particles.

Figure 3

KPA-0783

Figure 4