CORNING SRP-004-067 Руководство по эксплуатации - Страница 4

Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Кабели и разъемы CORNING SRP-004-067. CORNING SRP-004-067 4 страницы. Access tool for sst-drop cables

Печатать страницу

Step 7:

Use scissors to remove the split

section of cable jacket and to cut

the strength members as flush as

possible to the cable jacket

(Figure 9). Use care to avoid

damaging the buffer tube. Access

the fibers as described by

SRP-004-067.

Maintenance

Over time, debris may build up in the stripping channel.

Keep the channel clean to augment blade life. If the

channel becomes very dirty or if the blades need to be

replaced, perform the following steps:

Step 1:

Two Phillips-head screws secure the blade

guides in the access tool. Use a Phillips-head

screwdriver to back-out one of the screws to the

point the blade guides can be lifted from the tool

(Figure 10, top).

Step 2:

Remove and replace the blade in the guide

(Figure 10, middle).

Step 3:

Reinsert the blade guide and secure it with its

Phillips-head screw (Figure 10, bottom).

Step 4:

Repeat steps 1 - 3 for the other blade.

NOTE: If additional spare blades are needed, standard

"mini-utility knife" blades are used in the tool, such

as ACE® p/n 23301; US Blade p/n 117-82b1,

Kobalt® p/n 078010.

If lost, the blade guide retaining screws may be

replaced by 6-32 x 3/8 inch stainless steel screws.

Corning Cable Systems LLC √ PO Box 489 √ Hickory, NC 28603-0489 USA

1-800-743-2671 √ FAX +1-828-325-5060 √ International +1-828-901-5000 √ http://www.corning.com/cablesystems

Corning Cable Systems reserves the right to improve, enhance, and modify the features and specifications of Corning Cable Systems' products without prior notification.

SST-Drop is a trademark of Corning Cable Systems Brands, Inc. All other trademarks are the properties of their respective owners. Corning Cable Systems is ISO 9001 certified.

STANDARD RECOMMENDED PROCEDURE 005-066 | ISSUE 4 | JULY 2010 | PAGE 4 OF 4

Figure 9 — Mid-span strength member removal

Figure 10 — Blade replacement

KPA-2463

KPA-2464