CORNING ONE HEU Лист быстрой установки - Страница 5

Просмотреть онлайн или скачать pdf Лист быстрой установки для Измерительные приборы CORNING ONE HEU. CORNING ONE HEU 12 страниц. Headend unit

CONNECT RIMS TO RF SOURCE(S)

For each RIMe — connect the external RF source to the

corresponding RIMe (service specific) simplex or duplex

QMA connectors. See Figure 7.

RIX TO OIX CONNECTIONS

Note: Each RIX module can be connected to two OIUs.

Using the appropriate length ERFC cable (according to distance

of available OIX port), connect the HEU RIX module 9-Pin

connector to the corresponding connector on the OIU OIX

module. See Figure 8.

Refer to Section 11 for schematic diagram of coax connections

in a maximum HEU-OIU configuration of 4x4 where all HEU

units are connected to all OIU units.

RIX PILOT CLOCK CONNECTIONS

The pilot clock connections are required in both single- and

multiple-chassis configurations. Referring to Figures 9, 10, and

11, use the QMA/QMA jumper cable (PCKC47 provided with

each RIX) to connect the REF OUT and REF IN ports of each of

the RIXs in the HEU chassis.

Notes:

• The REF IN and REF OUT pilot clock ports must be

connected in a closed loop as shown in Figure 10.

• Both RIX modules of each chassis must be

connected.

Corning Optical Communications

Figure 7. RIM RF Source Interfaces

Figure 8. HEU to OIU Coax Connections

Figure 9. Pilot Clock Connections Example –

Single HEU with Two RIXs

Quick Installation Sheet | CMA-267-AEN | Page 5