Makita 5091DWG Руководство по эксплуатации - Страница 9

Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Электроинструмент Makita 5091DWG. Makita 5091DWG 18 страниц. 85 mm (3-3/8")

Installing or removing

the

battery cartridge

Always switch off the tool before insertion or removal of the battery cartridge.

To remove the battery cartridge, pull out

the set plate on the tool and grasp both

sides of the cartridge while withdrawing it

from the tool.

To insert the battery cartridge, align the

tongue on the battery cartridge with the

groove in the housing and slip it into

place. Snap the set plate back into place.

Be sure to close the set plate fully before

using the tool.

Battery cartridge

Fig.

Do not use force when inserting the battery cartridge.

If the cartridge does not slide in easily, it is not being inserted correctly.

Charging

Your new battery cartridge i s not charged.

You will need t o charge it before use. Use

the fast charger Model DC1201 t o charge

the battery cartridge.

*Plug the fast charger into the proper A/C

voltage source. The charging light will

flash in green color.

Insert the battery cartridge so that the

plus and minus terminals on the battery

cartridge are on the same sides as their

respective markings on the fast charger.

Insert the cartridge fully into the port so that it rests on the charger port floor.

When the battery cartridge is inserted, the charging light color will change from green t o

red and charging will begin. The charging light will remain lit steadily during charging.

*When charging i s completed, the charging light color will change from red to green and

a tone will sound steadily for about 5 seconds.

After charging, unplug the charger from the power source. Refer t o the table below for

the charging time.

Fig.

Fast charger

DC1201

1200

Approx.

min

1201 / 1201A

ADDrOX. 60 min