CORNING Universal Access Tool 3 Руководство по эксплуатации - Страница 8

Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Инструменты CORNING Universal Access Tool 3. CORNING Universal Access Tool 3 9 страниц.
Также для CORNING Universal Access Tool 3: Руководство по эксплуатации (18 страниц)

Печатать страницу

8. Preparing the Fibers for Splicing

8.1 Complete the cable splicing and installation according to the instructions for

the particular terminal or closure being installed.

9. Tool Storage and Cleaning

9.1 Turn the top and bottom blade depth adjustment assemblies counterclockwise

to their Raised "A" settings to retract the blades inside the tool before closing the

tool for storage.

9.2 The handle must be removed from the tool before

is placed in its storage

case. Use the 3/8-inch wrench provided with the tool to hold the tool's drive shaft

while loosening the handle (Figure 21).

Figure 21

9.3 The blades and drive wheels are potentially susceptible to corrosion. If the

tool is going to be stored in a damp environment, apply a light weight penetrating

oil to the tool to prevent corrosion. A1:ways keep the tool in its case when not in use.

9.4 The tool may be cleaned with a cloth dampened with alcohol or filling

compound remover.

9.5 Before and after every use of the tool, inspect the teeth of its drive wheels

for any accumulation of debris. Use a plastic-brisded brush to remove any debris

found in the teeth. Check the tool's rollers for filling compound or other contami

nants and clean the rollers as necessary.

SRP-004-074

10. Blade Replacement

Note:

you are

the middle ofa mid-span-access cut, note the coarse and fine adjust

ment wheel settings. You will need these settings to re-position the blade assembly after blade

replacement.

:::.

10.1 To replace a blade:

a) Remove the blade height

adjustment assembly to expose

the top of the blade assembly

(Figure 22).

b) Turn the tool upside down over a cupped hand or a container resting on a work

surface and let the blade assembly and spring fall out of the tool (Figure 23).

~.pm

Figure 23

the blade assembly does not

jUlt

foil out, shake the tool slightly or press on the end ofthe

blade assembly with the end ofa small screwdriver to free the assembly and spring.

c) Plaee the spring over a new blade assembly.

d) Thm the tool on its side. Orient the blade so that its cutting edge is facing the

cutting direction arrow on the tool (see Figure 24). It is possible to insert the blade

backwards in the tool- verifY that the blade is focing the correct direction.

e) Tip the tool up so that the blade

assembly slides into the tool. Use a small

=®

flat blade screwdriver to

turn

the blade

SpringB

until it slips into the slot.

Blade assembly

It is possible for the blade to slip between

the coils ofthe spring during assembly.

lfyou feel resistance, check the spring

placement.

Figure 24

10.2 Rcinstlllll'he blade depth lldjnstmcnt asscmbly and reset the coarse and fine

adjustment wheels - he sure that: the scttings arc "A-A" prior to closing the tool.

Note:

The top and bottom "'fide beiglJl

{lliju,mm'nt

assemblies are not interchangeable. The

assembly with the Tis fo?' tbe top brdfoftbe tool and the assembly with B is for the bottom

halfofthe tool.

SRP-004-074