Makita 9910 Руководство по эксплуатации - Страница 7

Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Электроинструмент Makita 9910. Makita 9910 13 страниц. 76mm
Также для Makita 9910: Разбивка на части (3 страниц), Руководство по эксплуатации (17 страниц), Разбивка на части (3 страниц), Руководство по эксплуатации (8 страниц), Руководство по эксплуатации (8 страниц), Техническая информация (5 страниц), Руководство по эксплуатации (17 страниц)

OPERATION

1. Clamps

1. Limit mark

1. Screwdriver

2. Brush holder cap

Sanding operation

004232

CAUTION:

•

The tool should not be in contact with the workpiece surface when you

turn the tool on or off. Otherwise a poor sanding finish or damage of the

belt may result.

Hold the tool firmly with both hands. Turn the tool on and wait until it attains full

speed. Then gently place the tool on the workpiece surface. Keep the belt

flush with the workpiece at all times and move the tool back and forth.

Never force the tool. The weight of the tool applies adequate pressure. Exces-

sive pressure may cause stalling, overheating of the motor, burning of the

workpiece and possible kickback.

Clamps (optional accessory)

This machine can be operated in the inverted position. To do so, secure the

004140

machine to a stable workbench with two clamps.

CAUTION:

•

Always be sure that the tool is switched off and unplugged before

attempting to perform inspection or maintenance.

Replacing carbon brushes

001145

Remove and check the carbon brushes regularly. Replace them when they are

worn down to the limit mark. Keep the carbon brushes clean and free to slip in

the holders. Both carbon brushes should be replaced at the same time. Use

only identical carbon brushes.

Use a screwdriver to remove the brush holder caps. Take out the worn carbon

003398

brushes, insert the new ones and secure the brush holder caps.